Abstract:Deadbeat predictive current control (DBPCC) has the characteristic of fast current response, but it is sensitive to motor parameters. Observer-based DBPCC can eliminate the steady state current tracking error when parameter mismatch exists. However, the actual current will deviate from the reference current during transient state in the case of inductance mismatch. In this paper, a fast response robust deadbeat predictive current control (FRRDBPCC) method is proposed for surface mounted permanent magnet synchronous motor (SPMSM). Firstly, the current tracking error caused by inductance mismatch during transient state is analyzed in detail. Then, an extended state observer (ESO) is proposed to estimate the lumped disturbance caused by parameter mismatch. Based on discrete time ESO, the predicted currents are used to replace the sampled currents to compensate for one-step delay caused by calculation and sampling. Furthermore, an online inductance identification algorithm and a modified prediction model are proposed. The dq-axis currents can be completely decoupled by updating the inductance in the modified prediction model online, ensuring that the current can track the reference value in two control periods. The proposed method improves robustness against parameter mismatch and guarantees dynamic response performance simultaneously. The experimental results verify the effectiveness of the proposed method.

Transient Current Ratio Dendrite Net for High-Resistance Connection Diagnosis in BLDCM

A Novel Magnetization Failure Detection Method for 1-Phase BLDC Motor Based on Back-EMF Test

Diagnosis of High-Resistance Connection Faults in PMSMs Based on GMR and Deep Learning

Analysis of Inter-Turn Short-Circuit Faults in Brushless DC Motors Based on Magnetic Leakage Flux and Back Propagation Neural Network

A Fast Response Robust Deadbeat Predictive Current Control for Permanent Magnet Synchronous Motor

An Input Current Based Method for Fault Diagnosis of High Resistance Connection in BLDC Motors

Diagnosis of Interturn Short Circuit Fault in BLDCM Based on Coupled High-Frequency Signal Injection

High-Resistance Connection Diagnosis in Five-Phase PMSMs Based on the Method of Magnetic Field Pendulous Oscillation and Symmetrical Components

Direct Instantaneous Torque Control of Srm Based on New Flux Linkage Detection Method

A Fault-Tolerant Direct Torque Control Strategy for A Brushless Dc Motor Driven by A Single Sided Matrix Converter

Comparative Performance Evaluation of Hall Effect Sensorless Control Options in Permanent Magnet Brushless DC Motor Drives

Low-Cost Direct Instantaneous Torque Control for Switched Reluctance Motors with Bus Current Detection under Soft-Chopping Mode

A Practical Method to Eliminate the Conduction Torque Ripple in BLDCM Using Cascade Topology

A Novel Commutation Torque Ripple Suppression Scheme in BLDCM by Sensing the DC Current

Detection and Evaluation of the Inter-turn Short Circuit Fault in a BLDC-Based Hub Motor

A Novel Control Method for Rotor Eddy Current Loss Reduction of High-Speed Permanent Magnet Brushless DC Motors

A Simple and Practical Duty Cycle Modulated Direct Torque Control for Permanent Magnet Synchronous Motors

Direct Torque Control for Three-Phase Open-End Winding PMSM With Common DC Bus Based on Duty Ratio Modulation

A Novel Direct Torque Control Method for Brushless DC Motors Based on Duty Ratio Control

Five-Level Hysteresis DTC of Open-End Winding Permanent Magnet Synchronous Motors With Zero-Sequence Currents Suppression and Torque Ripple Reduction.

A Comprehensive Interturn Fault Severity Diagnosis Method for Permanent Magnet Synchronous Motors Based on Transformer Neural Networks