Abstract:Torque ripple reduction based on harmonic current injection has been widely applied to surface-mounted permanent-magnet synchronous machine (SPMSM) drive systems. However, additional voltages are typically required for harmonic injection, and the dc-link voltage limit should be considered in practical drive systems. This article proposes a novel harmonic control for SPMSMs in which the torque ripple reduction and high dc-link voltage utilization can be achieved simultaneously. The influence of harmonic injection on voltage utilization is investigated in detail. In addition to injecting the appropriate q -axis harmonic currents to suppress torque ripple, the d -axis harmonics are also optimized and injected. The geometric principle is applied to obtain the analytical expression for the optimal d -axis harmonic voltage, which can minimize the maximum magnitude of the stator voltage vector. Since the reference harmonic voltage is directly calculated in accordance with the analytical solution, the implementation complexity of harmonic voltage regulation is relatively low. Moreover, a virtual dual three-phase system with auxiliary currents is developed to decompose the fundamental and harmonic currents without low-pass filters, thus avoiding additional delay in the control loop. Finally, the experimental results are provided to verify the validity of the proposed method.

A Novel Commutation Torque Ripple Suppression Scheme in BLDCM by Sensing the DC Current

Reduction of Commutation Torque Ripple in Brushless DC Motors

A Novel Harmonic Current Control Method for Torque Ripple Reduction of SPMSM Considering DC-Link Voltage Limit

Research on PWM Method in Brushless DC Motor

A Novel Strategy to Suppress Commutation Torque Ripple in Brushless DC Motor Based on Unitive Formula

A Practical Method to Eliminate the Conduction Torque Ripple in BLDCM Using Cascade Topology

A Novel PWM Scheme to Eliminate the Diode Freewheeling in the Inactive Phase in BLDC Motor

A New BLDC Motor Drives Method Based on BUCK Converter for Torque Ripple Reduction

Research on Suppressing Commutation Torque Ripple of BLDCM Based on Zeta Converter

Conduction Torque Ripple in BLDCM Based on Energy Unit Method

Research on BLDC Motor Torque Ripple with Specific Modulation Duty Cycle Control During Commutation

New BLDCM Drive Method to Smooth the Torque

Torque Ripple Suppression Method for BLDCM Drive Based on Four-Switch Three-Phase Inverter

Torque Ripple Reduction Strategy for Brushless DC Motor Based on Output Mode Reconstruction of Cuk Converter

Torque ripple reduction of BLDC motor based on DC bus voltage automatic selection circuit and neutral point clamped three-level inverter control

Torque Ripple Reduction of Brushless Dc Motor on Current Prediction and Overlapping Commutation

Commutation Torque Ripple Restraint in BLDC Motor over Whole Speed Range

Model Predictive Control Method of Torque Ripple Reduction for BLDC Motor

A New Torque Control Method for Torque Ripple Minimization of BLDC Motors with Un-Ideal Back EMF

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Research on Torque Ripple Minimization of Position-Sensorless Brushless DC Motor