Abstract:In this paper, a new torque controller is proposed for optimizing the torque tracking performance in direct torque control (DTC) system of brushless doubly fed machine (BDFM) drives. This paper starts from the change rate equation of torque, theoretically analyzes the change rate of torque characteristics, and illustrates the relation between the motor torque and flux and voltage. The double comparator torque controller is proposed to replace the conventional torque hysteresis comparator of the DTC. In the proposed torque controller, a PI controller is designed and combined with two comparators. The stability of the adaptive terminal sliding mode motion is verified by using the Lyapunov function. The improved DTC strategy retains the simple structure of the three-level voltage vector switch table. At the same time, the torque ripple is decreased obviously and constant switching frequency is maintained. In particular, the larger torque ripple problem that normally occurs in DTC with the hysteresis comparator at low speed is solved. Under different operating conditions, the performances of the conventional DTC and improved DTC are compared with experiments. Experimental results of the improved DTC verified the validity and showed a substantial improvement. It is evident that the torque ripple is reduced from 10 to 2 Nm, and the switching frequency of torque controller is constant (5 kHz). The improved DTC strategy has good speed tracking and decoupling performance.

A Novel Direct Torque Control Method for Brushless DC Motors Based on Duty Ratio Control

Investigation Of Direct Torque Control And Torque Sharing Function Strategy For Switched Reluctance Motor Applications

Research on Torque Ripple Minimization Strategy for Direct Torque Control of Induction Motors

Reduction of Commutation Torque Ripple in Brushless DC Motors

Direct Torque Control with Zero-Voltage Vector for a Permanent Magnet Synchronous Motor

Direct Torque Control of Induction Motors Based on Improved Discrete Duty Ratio Control Technology

A Novel Sequential Direct Torque Control Scheme for Seven-phase Induction Motors

A Novel Duty-Controlled DTC of a Surface PMSM Drive With Reduced Torque and Flux Ripples

A Torque Ripple Minimization Scheme in Direct Torque Control of Induction Motors

Research on Direct Torque Control of Induction Machine Based on Torque Prediction

Direct Torque Control for Brushless DC Motors in Aerospace Applications with Single Sided Matrix Converters with Reduced Torque Ripple

Improved Torque Controller for Enhancing Performance at Full Speed Range of Direct Torque Control of Brushless Doubly Fed Machine

Direct Torque Control for Induction Motors Based on Minimum Voltage Vector Error

Changing Duty Ratio PWM Control of Direct-drive Air Compressor

A Fault-Tolerant Direct Torque Control Strategy for A Brushless Dc Motor Driven by A Single Sided Matrix Converter

A Novel Switching-Table-Based Direct Torque Control with Improved Current and Torque Steady-State Performance for Dual Three-Phase PMSM

Improved Direct Torque Control of Induction Motor for Torque Ripple Minimization

Torque Direct Control Method for BLDC Motors with Non-Ideal Back EMF Waveforms

A novel direct torque control method for switched reluctance motors based on optimal turn-on angle

A Novel Strategy to Suppress Commutation Torque Ripple in Brushless DC Motor Based on Unitive Formula

A Simple and Practical Duty Cycle Modulated Direct Torque Control for Permanent Magnet Synchronous Motors