A Novel Switching-Table-Based Direct Torque Control with Improved Current and Torque Steady-State Performance for Dual Three-Phase PMSM

Yu Liu,Xiaohui Huang,Sheng Huang,Wu Liao,Ge Liang,Congqi Feng,Xuan Wu,Shoudao Huang

DOI: https://doi.org/10.1109/tte.2023.3305540

IF: 6.519

2023-01-01

IEEE Transactions on Transportation Electrification

Abstract:The classical switching-table-based direct torque control (ST-DTC) suffers from issues such as large torque ripples, significant current harmonics, and variable switching frequency. In this paper, a novel ST-DTC is proposed to improve the current and torque steady-state performance for dual three-phase permanent magnet synchronous motor (DTP-PMSM). Firstly, proportional resonance (PR) controllers are used in the x-y subspace, and the x-y reference voltage generated by PR controllers is modulated by three fixed vectors based on the analysis of flux and torque slopes of voltage vectors with different amplitudes. This reduces current harmonics and computational burden of modulating the x-y reference voltage. Secondly, duty-ratio modulation is employed to reduce the torque ripple. However, under the traditional torque regulator, the duty-ratio modulation exists a torque range where it cannot achieve the instantaneous zero error of torque at the end of the control period. Therefore, the feedback value of the torque regulator is modified to further suppress torque ripple. Furthermore, to prevent generating incorrect switch sequences caused by the short dwell time of vectors and maintain the thermal balance of the inverter, an optimization of the switching sequence is performed. Finally, experimental results are presented to validate the effectiveness of the proposed method.

engineering, electrical & electronic,transportation science & technology

What problem does this paper attempt to address?

A Novel Switching-Table-Based Direct Torque Control with Improved Current and Torque Steady-State Performance for Dual Three-Phase PMSM

Investigation Of Direct Torque Control And Torque Sharing Function Strategy For Switched Reluctance Motor Applications

Torque Ripple Suppression Control for Dual Three-Phase Permanent-Magnet Synchronous Motor

Study on Switching Strategy of PMSM and BLDCM

Multi-level Converter-Based Torque Sharing Function Control Strategy for Switched Reluctance Motors

Optimized Direct Instantaneous Torque Control for SRMs With Efficiency Improvement

Direct Torque Control for 2L-VSI PMSM Using Switching Instant Table.

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

Study On Direct Torque Control Of Dual Y Shift 30 Degree Six-Phase Pmsm

Direct Torque Control Schemes for Dual Three-Phase PMSM Considering Unbalanced DC-link Voltages

A Novel Direct Torque Control Method with the Compensation of Rotating EMF to Reduce Torque Ripple for Permanent Magnet Synchronous Motor Drives

Direct Torque Control for Three-Phase Open-End Winding PMSM With Common DC Bus Based on Duty Ratio Modulation

Direct torque control for synchronous reluctance motor based on space vector modulation

The PMSM DTC Based on Variable Structure Sliding Mode

A Novel Sliding Hysteresis Band Based Direct Torque Control Scheme for PMSM Motors to Achieve Improved Current THD With Reduction in Torque and Flux Ripples Eliminating the Low-Speed Problems

Simulation and experiment on direct torque control based on space vector pulse width modulation of PMSM

Torque Ripple Reduction of the Torque Predictive Control Scheme for Permanent-Magnet Synchronous Motors

Study on the direct torque control of permanent magnet synchronous motor drives

Improved Direct Torque Control for Open-Winding PMSM System Considering Zero-Sequence Current Suppression with Low Switching Frequency

Fuzzy Logic Direct Torque Control for Permanent Magnet Synchronous Motors

Torque-Performance Improvement for Direct Torque-Controlled PMSM Drives Based on Duty-Ratio Regulation