Abstract:In this paper, a new torque controller is proposed for optimizing the torque tracking performance in direct torque control (DTC) system of brushless doubly fed machine (BDFM) drives. This paper starts from the change rate equation of torque, theoretically analyzes the change rate of torque characteristics, and illustrates the relation between the motor torque and flux and voltage. The double comparator torque controller is proposed to replace the conventional torque hysteresis comparator of the DTC. In the proposed torque controller, a PI controller is designed and combined with two comparators. The stability of the adaptive terminal sliding mode motion is verified by using the Lyapunov function. The improved DTC strategy retains the simple structure of the three-level voltage vector switch table. At the same time, the torque ripple is decreased obviously and constant switching frequency is maintained. In particular, the larger torque ripple problem that normally occurs in DTC with the hysteresis comparator at low speed is solved. Under different operating conditions, the performances of the conventional DTC and improved DTC are compared with experiments. Experimental results of the improved DTC verified the validity and showed a substantial improvement. It is evident that the torque ripple is reduced from 10 to 2 Nm, and the switching frequency of torque controller is constant (5 kHz). The improved DTC strategy has good speed tracking and decoupling performance.

Improved Torque Controller for Enhancing Performance at Full Speed Range of Direct Torque Control of Brushless Doubly Fed Machine

Investigation Of Direct Torque Control And Torque Sharing Function Strategy For Switched Reluctance Motor Applications

Improved Direct Torque Double Closed-Loop Control Algorithm for Induction Motor

Research on Fuzzy Direct Torque Controlling System of Induction Machine with Fuzzy Speed Regulator

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

A new full-speed range direct torque control strategy for induction machine

Direct Torque Control for Brushless DC Motors in Aerospace Applications with Single Sided Matrix Converters with Reduced Torque Ripple

A Novel Direct Torque Control Method for Brushless DC Motors Based on Duty Ratio Control

Research on Direct Torque Control of Induction Machine Based on Torque Prediction

Flux Linkage Self-control Based Direct Torque Control of Brushless DC Motor

A Fault-Tolerant Direct Torque Control Strategy for A Brushless Dc Motor Driven by A Single Sided Matrix Converter

Research on Torque Ripple Minimization Strategy for Direct Torque Control of Induction Motors

A Novel Switching-Table-Based Direct Torque Control with Improved Current and Torque Steady-State Performance for Dual Three-Phase PMSM

Novel deadbeat direct torque and flux control for interior permanent magnet synchronous motor

Optimized Direct Instantaneous Torque Control for SRMs With Efficiency Improvement

Improved Direct Torque Control strategy for Wide Range Speed Control of Induction Motor Drives

Torque-Performance Improvement for Direct Torque-Controlled PMSM Drives Based on Duty-Ratio Regulation

STUDY ON THE PERFORMANCE OF DIFFERENT DIRECT TORQUE CONTROL METHODS FOR PERMANENT MAGNET SYNCHRONOUS MACHINES

Fuzzy Logic Direct Torque Control for Permanent Magnet Synchronous Motors

An Improved Direct Torque Control of Surface Permanent Magnet Synchronous Motor Drives Using Space Vector Modulation

An Improved Directtorque Control Technology Study for Permanent Magnet Synchronous Motor