Abstract:The traditional direct torque control (DTC) strategy utilizes the largest 14 voltage vectors for a seven-phase induction machine (7PIM), which is directly extended from the three-phase counterparts. This method suffers from the issues of severe harmonic currents and torque ripple for multiphase ones. This article first puts forward the concept of virtual vectors for a 7PIM. This can efficiently eliminate the third- and fifth-order harmonic currents. However, the DTC strategy based on the virtual voltage vector has insignificant effect on reducing the torque ripple. Then, the torque ripple caused by these virtual vectors in different torque and speed conditions is investigated. Analysis shows that there are some additional degrees of freedom while choosing the applied voltage vector. A novel sequential strategy integrated with duty ratio optimization algorithm is proposed to select the optimal voltage vector that can significantly alleviate the torque ripple. Experimental results verified that the proposed method can effectively reduce the dynamic and steady-state torque ripple as well as the harmonic current.This article utilizes a 7PIM for an illustration, but it should be mentioned here that the proposed strategy is applicable for multiphase machines with any number of phases.

Direct Torque Control with Zero-Voltage Vector for a Permanent Magnet Synchronous Motor

Direct Torque Control for 2L-VSI PMSM Using Switching Instant Table.

A Sequential Direct Torque Control Scheme for Seven-Phase Induction Machines Based on Virtual Voltage Vectors

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

Improved Direct Torque Control of Permanent Magnet Synchronous Motor in Electric Vehicle Drive

Fuzzy Logic Direct Torque Control for Permanent Magnet Synchronous Motors

Improved Direct Torque Control for Open-Winding PMSM System Considering Zero-Sequence Current Suppression with Low Switching Frequency

Analysis of direct torque control in permanent magnet synchronous motor drives

Study on the direct torque control of permanent magnet synchronous motor drives

Sensorless Direct Torque Control for Permanent Magnet Synchronous Motor Based on Fuzzy Logic

Direct Torque Control of Permanent Magnet Synchronous Motor with SVM

Research on Fuzzy Direct Torque Controlling System of Induction Machine with Fuzzy Speed Regulator

Continuous Direct Torque Control of Permanent Magnet Synchronous Motor Based on Svm

A Fuzzy Dtc Method with A Svm Defuzzification to Permanent Magnet Synchronous Machine

Torque and Flux Weakening Control with MTPV for Interior Permanent Magnet Synchronous Motor

Research on Torque Ripple Minimization Strategy for Direct Torque Control of Induction Motors

STUDY ON THE PERFORMANCE OF DIFFERENT DIRECT TORQUE CONTROL METHODS FOR PERMANENT MAGNET SYNCHRONOUS MACHINES

Research on Direct Torque Control of Induction Machine Based on Torque Prediction

A V/Hz Based Maximum Torque Per Volt Control in Flux-Weakening Region for Interior Permanent Magnet Synchronous Motors

A Novel Torque Ripple Reduction Strategy for Predictive Direct Torque Controlled Pmsg

A new full-speed range direct torque control strategy for induction machine