Abstract:Oxide dispersion strengthened (ODS) steels are promising materials for high temperature applications, in particular in fission and fusion nuclear reactors. In comparison to common reduced activation ferritic/martensitic steels they exhibit better resistance to neutron irradiation and creep owing to an uniform dispersion of nano-oxides particles (~5 nm) and a very fine grain structure (~500 nm). ODS steels are commonly prepared by high-energy mechanical alloying (HEMA) of a mixture of steel powder and Y2O3 particles followed by a consolidation stage consisting of hot extrusion (HE) or hot isostatic pressing (HIP). The samples are then submitted to annealing around 1100°C for 1-2 hours. Recently, the present authors proposed a novel method based on low-energy mechanical alloying (LEMA). In general ODS microstructure is quite complex and several mechanisms contribute to the mechanical strengthening with different effects depending on the temperature. The present work analyses the role played by each single mechanism at increasing temperature by considering the specific microstructural features. ODS steels prepared through different routes and process parameters display different grain size distribution and homogeneity of particles dispersion, factors which strongly affect the mechanical properties. Yield stress values measured in tensile tests performed at increasing temperature up to 700°C, either taken from literature or achieved by authors, have been examined and the following strengthening mechanisms have been considered to fit the experimental data: (i) solid solution; (ii) Bailey-Hirsch; (iii) Hall-Petch; (iv) Orowan; (v) Coble creep and (vi) Arzt-Rősler-Wilkinson. The analyses evidence advantages and drawbacks of different preparation routes and suggest some criteria for further improving the mechanical properties of these materials.

Ultra-fine grained EUROFER97 steel for nuclear fusion applications

Characterization of Ductile Nano-Tic Dispersed V4Cr4Ti/RAFMs Solid Diffusion Joint for Nuclear Fusion Reactor Application

Technical Issues for the Fabrication of A Cn-Hccb-Tbm Based on Rafm Steel Clf-1

Low cycle fatigue of EUROFER97 investigated for Test Blanket Modules of ITER: An interlaboratory study

Microstructural and material property changes in severely deformed Eurofer-97

In-Situ Synchrotron Investigation of the Elastic and Tensile Properties of Oxide Dispersion Strengthened EUROFER97 Steel

High cycle fatigue response of grain refined EUROFER97

Grain size manipulation of the Eurofer steel via mechanical alloying

Microstructure-specific Hardening of Ferritic-Martensitic Steels Pre and Post 15 Dpa Neutron Irradiation at 330 °C: A Dislocation Dynamics Study

Preliminary Characterization of Alumina-Forming Austenitic–Type Advanced Alloys as Structural Materials for LFRs

Recent Progress in Developing and Qualifying Nanostructured Ferritic Alloys for Advanced Fission and Fusion Applications

Small-angle neutron scattering applied to low-dose neutron-irradiated Fe-Cr alloys and ferritic martensitic steel Eurofer97

Grain Refinement Mechanisms and Strength-Hardness Correlation of Ultra-Fine Grained Grade 91 Steel Processed by Equal Channel Angular Extrusion

Development of irradiation tolerant tungsten alloys for high temperature nuclear applications

Cost-Effective Thermomechanical Processing of Nanostructured Ferritic Alloys: Microstructure and Mechanical Properties Investigation

Development of reduced activation ferritic/martensitic steels in China

Design of Reduced Activation Ferritic/Martensitic Steels by Multiphase Optimization During the Entire Processing

Microstructural Evolution and High‐Temperature Tensile Properties of 15Cr‐Reduced Activation Ferritic Steel Processed by Hot Powder Forging of Mechanically Alloyed Powders

Analysis of Strengthening Mechanisms in Nano-ODS Steel Depending on Preparation Route

Deuterium transport and retention properties of representative fusion blanket structural materials

XPS study of Cr segregation in a martensitic stainless steel