Abstract:This paper presents the results of physical modelling of the process of multi-pass rolling of a wire rod with controlled, multi-stage cooling. The main goal of this study was to verify the possibility of using a torsion plastometer, which allows conducting tests on multi-sequence torsion, tensile, compression and in the so-called complex strain state to physically replicate the actual technological process. The advantage of the research methodology proposed in this paper in relation to work published so far, is its ability to replicate the entire deformation cycle while precisely preserving the temperature of the deformed material during individual stages of the reproduced technological process and its ability to quickly and accurately determine selected mechanical properties during a static tensile test. Changes in the most important parameters of the process (strain, strain rate, temperature, and yield stress) were analyzed for each variant. After physical modelling, the material was subjected to metallographic and hardness tests. Then, on the basis of mathematical models and using measurements of the average grain size, chemical composition, and hardness, the yield strength, ultimate tensile strength, and plasticity reserve were determined. The scope of the tests also included determining selected mechanical properties during a static tensile test. The obtained results were verified by comparing to results obtained under industrial conditions. The best variant was a variant consisting of physically replicating the rolling process in a bar rolling mill as multi-sequence non-free torsion; the rolling process in an NTM block (no twist mill) as non-free continuous torsion, with the total strain equal to the actual strain occurring at this stage of the technological process; and the rolling process in an RSM block (reducing and sizing mill) as tension, while maintaining the total strain value in this block. The differences between the most important mechanical parameters determined during a static tensile test of a wire rod under industrial conditions and the material after physical modelling were 1.5% for yield strength, approximately 6.1% for ultimate tensile strength, and approximately 4.1% for the relative reduction of the area in the fracture and plasticity reserve.

Engineering estimates of strain and strain rate in helical rolling of balls

The central strain analytical modeling and analysis for the plate rolling process

Analytical and Finite Element Analysis of the Rolling Force for the Three-Roller Cylindrical Bending Process

Novel analytical heat source model for cold rolling based on an energy method and unified yield criterion

An analytical model of plate rolling force with a simple available velocity field and equal perimeter yield criterion

The theoretical model of the effective strain establishment for the plate during the snake rolling

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

The Analytical Model of Ball-Spinning Force for Processing an Annular Groove on the Inner Wall of a Steel Tube

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Numerical simulation of cold longitudinal asymmetric rolling process

Numerical Prediction of Microstructure Evolution of Small-Diameter Stainless Steel Balls during Cold Skew Rolling

Computer-Simulation Assessment of the Stress–Strain and Kinematic States of a Titanium Nickelide Billet during Screw Rolling

Mechanics and Modeling of Cold Rolling of Polymeric Films at Large Strains -- A Rate-Independent Approach

Innovative Methodology for Physical Modelling of Multi-Pass Wire Rod Rolling with the Use of a Variable Strain Scheme

Analysis of Temperature-Deformation Conditions for Rolling Aluminum Alloy Al–Mg–Sc Based on FEM Modeling

Modelling of axial thrust force between rolls in strip mill

Modelling of the Rolling Process of Titanium Alloy Tube Billets in Laboratory Conditions on a RSP 14-40 Rolling Mill

Assessment of shear strains, kinematic state, and deformation zone in two-high screw rolling processes

Research on the analytical model of rolling force for TiAl alloy pack rolling

Experimental testing of a new helical rolling technology

Interpretation of the strain state during cross-roll rolling of aluminum by means of texture analysis