Abstract:Cyclones are the most widely used separators at present, but it's still difficult to reduce their size to serve as pipe separators. A new type of gas liquid pipe separator for high velocity wet gas is proposed in this paper. The separator is actually a short section of pipe, with a centrifugal device in the center portion and 3 narrow tangential conduits (NTC) in the pipe wall. As gas liquid mixture flows through the centrifugal device downwardly, a strong rotation flow is created. Liquid in the mixture is pushed to the pipe wall by centrifugal force and forms a uniform liquid film with high tangential velocity. Then nearly all the liquid film can directly enter the NTC and be discharged from the pipe relying on its own kinetic energy and inertial, because of the little resistance characteristic of NTC to the liquid film, therefore the whole separation process can be completed within the pipe. The swirl characteristics in the pipe were studied by numerical method, and the simulation results indicated that the swirling liquid film is fairly uniform and the suitable installation position for NTC is about 2.5 pipe diameters downstream of the centrifugal device. A separation model for the pipe separator was established and experiments were carried out to verify the proposed model. The superficial velocity ranges of gas and liquid were 22-72 m/s and 0.07-0.54 m/s, respectively. The experimental results showed that the separation efficiency always increases with the increase of both gas and liquid superficial velocity, generally it is over 0.81, and the maximum attainable is 0.97. However, the separation efficiency will begin to drop if liquid superficial velocity exceeds the critical value U-CSL, due to the onset of unstable liquid film waves. Experimental results also showed that U-CSL, increases with the increase of gas velocity. (C) 2019 Elsevier Ltd. All rights reserved.

Control system for gas-liquid separation device

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Numerical Simulation and Experimental Investigation of Flow Field in Gas-Liquid Cylindrical Separator with Baffle Configuration

Research on the Performance of a Passive Gas-Liquid Separator Used in Space

Simulation research on the flow field performance of the supersonic separator for natural gas

Design of Structure and Control System for Spiral Tube Gas Liquid Separator

Experimental study on a new gas–liquid separator for a wide range of gas volume fraction

Experimental Study on a New Type of Separator for Gas Liquid Separation

Simulation and Experimental Validation of a New Separator Design for a Wide Range of Gas Volume Fractions

Research Progress of Membrane Contactor for Gas Separation

Passive Control of Gas–liquid Flow in a Separator Unit Using an Apertured Baffle in a Parallel-Flow Condenser

Experimental Study on a New Combined Gas–Liquid Separator

A novel horizontal gas–liquid pipe separator for wet gas based on the phase-isolation

Novel Membrane Contactors Used in Waste Gas/Liquid Separation

A Novel Centrifugal Gas Liquid Pipe Separator for High Velocity Wet Gas Separation

Design and simulation of an efficient gas-liquid separation device for component regulation of zeotropic mixtures

Oil-Gas-Water Three-Phase Flow Measurement Based on the Theory of Partial Separation

Experimental Study on Two Different Gas-Liquid Separators Under Different Flow Patterns

Separation mechanism and influential factor study on vane-type-associated petroleum gas separator

Gas-oil-water three-phase separating device

Research on Dissolved Gages in Oil Separation System