Separation mechanism and influential factor study on vane-type-associated petroleum gas separator

Shuo Liu,Jian Zhang,Li-Song Wang,Jing-Yu Xu

DOI: https://doi.org/10.1016/j.seppur.2020.117274

IF: 8.6

2020-11-01

Separation and Purification Technology

Abstract:<p>To investigate the separation mechanism of a vane-type separator, a flow experiment and a numerical simulation were conducted. Electrical resistance tomography and Coriolis mass flow meters were used during the flow experiment. An Eulerian multiphase model coupled with the Reynolds stress turbulent model was applied to conduct a corresponding numerical simulation. Based on the phase, the velocity, and the swirling intensity distribution, the separation performance of the separator was discussed in terms of the separation efficiency, the entrainment ratio, and the critical split ratio. Results showed that the swirling intensity was sensitive to the separator geometry and operating parameters. The separation efficiency increased with the split ratio under fixed entrance conditions. Once the split ratio was larger than the critical split ratio, the gas phase collected becomes maximal with a larger liquid phase collected in the branch exit if the split ratio increased continuously. Subsequently, based on the definition of split flow face, the gas–liquid separation mechanism was revealed by discussing the relative location of the gas–liquid interface and the split flow face. Finally, the relationships among the operating parameters including the exit pressure difference, the split ratio, and the liquid phase flow rate were analyzed based on the proposed separation mechanism model. This study provides a better understanding of the vane-type gas–liquid separation procedure and optimization.</p>

engineering, chemical

What problem does this paper attempt to address?

This paper mainly studies the separation mechanism of Associated Petroleum Gas (APG) produced together with oil in oil extraction. APG is usually treated as waste and burned, which can cause environmental and health problems. Therefore, it is crucial to study the separation technologies and mechanisms for APG in terms of environmental and economic benefits.

The paper investigates the separation mechanism of a blade separator through experiments and numerical simulations. Experimental techniques such as electrical resistance tomography and Coriolis mass flow meter were used to measure fluid distribution. In the numerical simulations, Eulerian multiphase model and Reynolds stress turbulence model were applied.

The study finds that the separation intensity is highly sensitive to the geometry and operating parameters of the separator, and the separation efficiency improves with the increase of the split ratio. When the split ratio exceeds the critical value, the gas collection reaches its maximum, and the liquid collection also increases at the branch outlet. The study further defines the splitting flow surface and reveals the influence of the relative position between the gas-liquid interface and the splitting flow surface on the separation mechanism. In addition, the paper analyzes the relationship between operating parameters such as pressure difference, split ratio, and liquid phase velocity, discussing them based on the proposed separation mechanism model.

The main contribution of the paper lies in deepening the understanding of the blade gas-liquid separation process and providing a theoretical basis for optimizing separator design. This helps to improve the separation efficiency of APG from production fluids, promoting its application in energy utilization and environmental protection.