Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. A simplified tire finite element model modeling and simulation method with high efficiency and accuracy is proposed to address the issues of poor efficiency and low accuracy in tire finite element simulation. Firstly, the detailed finite element model of the tire is established, and the viscoelastic material parameters are determined through theoretical analysis and simulation verification. Then, the Hyperelastic material parameters are obtained through cyclic Tensile testing, and finally, the static tire condition test verification is completed. Based on the established detailed finite element model of the tire, the influence of different rubber materials on the dynamic characteristics of the tire is studied. On this basis, simplified friction and structure models are proposed to complete the establishment of a simplified tire finite element model. The simulation results of lateral and longitudinal slip conditions are compared with experimental data by implanting a finite element friction model that considers slip velocity and contact pressure. Through simulation analysis, it was found that the tread compound has a significant impact on the dynamic characteristics of the tire, while other compounds have a relatively small impact. Simplifying the tire finite element model can significantly improve the efficiency of finite element simulation and reduce convergence issues. The comparison accuracy between the finite element model simulation results and experimental data is relatively high, with the average accuracy of longitudinal force, lateral force, and correction moment reaching 89%, 95%, and 81%, respectively. This verifies the correctness and effectiveness of the simplified tire finite element model modeling and simulation method. This method provides certain reference significance for improving the efficiency of tire finite element simulation and providing virtual matching between tires and the entire vehicle.

An embedded model of cord-reinforced rubber composites for aircraft tires

Mechanical properties of cord-rubber composites and tire finite element analysis

Application of Rebar Model in Finite Element Analysis of Tire

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Research on simplified tire finite element modeling and simulation method

Modeling and Validation of a Passenger Car Tire Using Finite Element Analysis

Study on the Load-Bearing Characteristics Analysis Model of Non-Pneumatic Tire with Composite Spokes

FINITE ELEMENT SIMULATION FOR STATIC LOAD TEST OF RADIAL TIRES

Finite Element Simulation of Radial Tire Building and Shaping Processes Using an Elasto-Viscoplastic Model

A simple anisotropic visco-hyperelastic constitutive model for cord-rubber composites

Finite Element Modeling for Steel Cord Analysis in Radial Tires

A NEW RUBBER-CORD COMPOSITE MODEL AND THE CORRESPONDING PARAMETER IDENTIFICATION SCHEME

A Novel Planar Tension Test of Rubber for Evaluating the Prediction Ability of the Modified Eight-Chain Model under Moderate Finite Deformation

Modeling Method of Constitutive Law of Rubber Hyperelasticity Based on Finite Element Simulations

Study on the Compressible Hyperelastic Constitutive Model of Tire Rubber Compounds under Moderate Finite Deformation

An Anisotropic Hyper-Visco-pseudo-elastic Model and Explicit Stress Solutions for Fabric Reinforced Rubber Composites

Finite Element Analysis and Experimental Investigation on Complex Steel Cord in Radial Tires

Analysis of Extension Propagation Process of Interface Crack Between Belts of a Radial Tire Using a Finite Element Method

Constitutive Relationship of Fabric Rubber Composites and Its Application

Influence of Belt Cord Angle on Radial Tire under Different Rolling States

A Novel Constitutive Model of Carbon Black Rubber for the Numerical Analysis of Press-Fitting of Rubber Bushing