Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. A simplified tire finite element model modeling and simulation method with high efficiency and accuracy is proposed to address the issues of poor efficiency and low accuracy in tire finite element simulation. Firstly, the detailed finite element model of the tire is established, and the viscoelastic material parameters are determined through theoretical analysis and simulation verification. Then, the Hyperelastic material parameters are obtained through cyclic Tensile testing, and finally, the static tire condition test verification is completed. Based on the established detailed finite element model of the tire, the influence of different rubber materials on the dynamic characteristics of the tire is studied. On this basis, simplified friction and structure models are proposed to complete the establishment of a simplified tire finite element model. The simulation results of lateral and longitudinal slip conditions are compared with experimental data by implanting a finite element friction model that considers slip velocity and contact pressure. Through simulation analysis, it was found that the tread compound has a significant impact on the dynamic characteristics of the tire, while other compounds have a relatively small impact. Simplifying the tire finite element model can significantly improve the efficiency of finite element simulation and reduce convergence issues. The comparison accuracy between the finite element model simulation results and experimental data is relatively high, with the average accuracy of longitudinal force, lateral force, and correction moment reaching 89%, 95%, and 81%, respectively. This verifies the correctness and effectiveness of the simplified tire finite element model modeling and simulation method. This method provides certain reference significance for improving the efficiency of tire finite element simulation and providing virtual matching between tires and the entire vehicle.

A Novel Planar Tension Test of Rubber for Evaluating the Prediction Ability of the Modified Eight-Chain Model under Moderate Finite Deformation

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Study on the Compressible Hyperelastic Constitutive Model of Tire Rubber Compounds under Moderate Finite Deformation

Test and Characterization for the Incompressible Hyperelastic Properties of Conditioned Rubbers under Moderate Finite Deformation

A Novel Constitutive Model of Carbon Black Rubber for the Numerical Analysis of Press-Fitting of Rubber Bushing

A three-dimensional constitutive model for the large stretch behavior of rubber elastic materials

A General Constitutive Model of Soft Elastomers

Experimental Investigation and Constitutive Modeling of Uncured Carbon Black Filled Rubber at Different Strain Rates

A Network Evolution Model for Recovery of the Mullins Effect in Filled Rubbers

Effects of Large Deformation and Velocity Impacts on the Mechanical Behavior of Filled Rubber: Microstructure-Based Constitutive Modeling and Mechanical Testing

A Novel Method for Constitutive Characterization of the Mechanical Properties of Uncured Rubber

Three-dimensional numerical simulations on the hyperelastic behavior of carbon-black particle filled rubbers under moderate finite deformation

CONSTITUTIVE PARAMETRIC EXPERIMENT OF TIRE RUBBER HYPERELASTIC LAWS WITH APPLICATION

Hyper-Pseudo-Viscoelastic Model and Parameter Identification for Describing Tensile Recovery Stress–Strain Responses of Rubber Components in TBR

A finite strain visco-hyperelastic damage model for rubber-like materials: theory and numerical implementation

Research on simplified tire finite element modeling and simulation method

A Nonlinear Viscoelastic Constitutive Model for Finite Deformation Rubber-like Materials

Finite Element Simulation of Radial Tire Building and Shaping Processes Using an Elasto-Viscoplastic Model

Large Isotropic Elastic Deformations: On a Comprehensive Model to Correlate the Theory and Experiments for Incompressible Rubber-Like Materials

Experimental Investigation and Constitutive Modeling of the Uncured Rubber Compound Based on the DMA Strain Scanning Method

Tension responses of carbon black filled rubbers at intermediate and high strain rates: Experimental investigation and modeling