Abstract:<p>Employing computer simulation to accurately and quantitatively predict the mechanical properties of polymeric materials is a long-standing challenge. Herein, we consider two methods to simulate the mechanical properties based on a fully atomistic model of crosslinked styrene-butadiene rubber (SBR) network via molecular dynamics simulation. In the first method (stepwise deformation and relaxation), by keeping the tensile velocity constant and regulating the simulation time that each deformation period takes, sufficient relaxation occurs in the consecutive deformation, which enables each deformation period followed by a corresponding relaxation period. The engineering stress-strain curve finally obtained by this stepwise deformation and relaxation method exhibits similar features of elastomers compared with the experimental results. The second method divides the whole deformation process into several discontinuous parts. Sufficient relaxation also occurs in several independent SBR systems at the specific strain and the relaxed stress plateau is indicated to represent the stress that SBR system exhibits at specific strain after allowing the system to relax. Compared with the traditional uniaxial tensile method (continuous deformation in constant strain rate) and the first method we adopt, the second method could also characterize the mechanical behavior of elastomers and improve the computational capability on the level of a large-scale system. Compared with the excessively large values obtained by traditional method, the elastic modulus, the modulus at 100%, 300% and 500% of the full atomistic SBR are calculated as 38.5 MPa, 12.0 MPa, 25.1 MPa and 83.1 MPa, respectively, which exhibits more realistic mechanical behavior and merely exceeds around one order of magnitude than the experimental results. These methods are believed to serve as a good basis for further accurately simulating and predicting the mechanical properties of elastomers.</p>

Experimental Investigation and Constitutive Modeling of the Uncured Rubber Compound Based on the DMA Strain Scanning Method

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Mechanical Behaviors of Copolymer Elastomers: Experimental Characterization and Constitutive Modelling

Experimental Investigation and Constitutive Modeling of Uncured Carbon Black Filled Rubber at Different Strain Rates

A Novel Method for Constitutive Characterization of the Mechanical Properties of Uncured Rubber

Effect of the temperature and strain rate on the tension response of uncured rubber: Experiments and modeling

RESEARCH ON NONLINEAR VISCOELASTIC CONSTITUTIVE MODEL FOR UNCURED RUBBER

Effects of Large Deformation and Velocity Impacts on the Mechanical Behavior of Filled Rubber: Microstructure-Based Constitutive Modeling and Mechanical Testing

A Network Evolution Model for Recovery of the Mullins Effect in Filled Rubbers

Network Alteration of Cyclically Loaded Elastomers Mediated by Dynamic Bonds

Molecular simulation guided constitutive modeling of filled rubber: Bridging structural parameters to constitutive equations

Compressive mechanical properties of styrene-butadiene rubber under medium-low strain rates: Experiments and modeling

A Novel Planar Tension Test of Rubber for Evaluating the Prediction Ability of the Modified Eight-Chain Model under Moderate Finite Deformation

Tension responses of carbon black filled rubbers at intermediate and high strain rates: Experimental investigation and modeling

Quantitatively predicting the mechanical behavior of elastomers via fully atomistic molecular dynamics simulation

Constitutive Model for Thermal-Oxygen-Aged EPDM Rubber Based on the Arrhenius Law

Experiments and modeling of the coupled viscoelasticity and Mullins effect in filled rubber materials

Dynamic constitutive modelling and mullins effect of elastic‐porous metal rubberDynamische Werkstoffmodellierung und Mullins‐Effekt von elastisch‐porösem Metallgummi

A three-dimensional constitutive model for the large stretch behavior of rubber elastic materials

A MD Simulation and Experimental Study

Modeling and simulation for the swelling behavior of unvulcanized rubber during the calendering process