Abstract:The optimization of thermal management (i.e. improving heat generation and dissipation) in a proton exchange membrane fuel cell (PEMFC) is a vital method to enhance its energy conversion efficiency. However, few studies have focused on the temperature uniformity in a massive PEMFC stack with a coolant flow channel. The aim of this study is to investigate the temperature characteristics and power performance affected by the inlet coolant condition in a massive PEMFC stack and establish a correlation of the temperature uniformity with the affected inlet coolant temperature for thermal management and power performance improvements in PEMFCs. The power density of a massive PEMFC stack with an active area of 326 cm 2 (302 mm × 108 mm) of the designed stack cells with a coolant flow channel were experimentally evaluated, and the thermal characteristics were also analyzed using monitored temperatures inside specific stack cells by considering the different inlet coolant temperatures of 50 °C, 60 °C and 70 °C. It was found that the stack had the greatest power performance and minimum temperature increment of the inlet coolant at a temperature of 70 °C. The water phase transition heat transfer inside the stack was found to play a significant role in the thermal balance. The temperature distribution of the stack cell had a symmetrical convex curve from the center to the margin. The temperature gradient of the stack cell along the coolant flow direction was introduced to characterize the temperature uniformity. The linear development between the temperature gradient and the current density was determined adequately using a curve fitting. In addition, a lower fitting linear slope was obtained for a higher inlet coolant temperature, and this signified that a higher inlet coolant temperature could improve the temperature uniformity and power performance of PEMFCs.

Study on the influence of the hydrogen–oxygen stoichiometric ratio on the power performance improvement in a large-scale PEMFC stack

Experimental study of the thermal and power performances of a proton exchange membrane fuel cell stack affected by the coolant temperature

In-Depth Understanding of Oxygen Transfer in the Catalyst Layer of High-Temperature Proton Exchange Membrane Fuel Cells

Numerical Study on Effect of Flow Field Configuration on Air-Breathing Proton Exchange Membrane Fuel Stacks

Optimization of Configurations and Cathode Operating Parameters on Liquid-Cooled Proton Exchange Membrane Fuel Cell Stacks by Orthogonal Method

Effects of operating conditions on the performance uniformity of the proton-exchange membrane fuel cell stack

An Electrochemical Performance Model Considering of Non-Uniform Gas Distribution Based on Porous Media Method in PEMFC Stack

Study on the Heat and Mass Transfer Mechanisms of Liquid-Cooled PEMFC Stacks Based on Non-Isothermal Model

Effect of oxidant quantity and humidification temperature on performance of PEMFC with twin inlet and twin outlet flow field

Comprehensive performance assessment and multi-objective optimization of high-power proton exchange membrane fuel cell system under variable load

Performance enhancement of air-cooled PEMFC stack by employing tapered oblique fin channels: Experimental study of a full stack and numerical analysis of a typical single cell

Entrance Effects on the Flow Distribution in Manifold of Commercial-Size Proton Exchange Membrane Fuel Cell Stacks

Enhancing heat dissipation and mass transfer of oxygen gas flow channel in a proton exchange membrane fuel cell using multiobjective topology optimization

Study on water and oxygen transfer characteristics of HT-PEM fuel cells

Optimal performance and modeling study of air-cooled proton exchange membrane fuel cell with various bipolar plate structure

Improved flow field design for air-cooled proton exchange membrane fuel cells

Manifold geometry optimization and flow distribution analysis in commercial-scale proton exchange membrane fuel cell stacks

Several Important Aspects of H2-air PEMFC Engine

Microscale structure optimization of catalyst layer for comprehensive performance enhancement in proton exchange membrane fuel cell

Experimental Investigation on the Open Cathode Air-Cooled Proton Exchange Membrane Fuel Cells: Optimum Operating Parameters and Control Strategies

Experimental study of voltage uniformity and stability of H 2 /O 2 PEM fuel cell stack with dead-end anode and recirculation cathode