Abstract:The optimization of thermal management (i.e. improving heat generation and dissipation) in a proton exchange membrane fuel cell (PEMFC) is a vital method to enhance its energy conversion efficiency. However, few studies have focused on the temperature uniformity in a massive PEMFC stack with a coolant flow channel. The aim of this study is to investigate the temperature characteristics and power performance affected by the inlet coolant condition in a massive PEMFC stack and establish a correlation of the temperature uniformity with the affected inlet coolant temperature for thermal management and power performance improvements in PEMFCs. The power density of a massive PEMFC stack with an active area of 326 cm 2 (302 mm × 108 mm) of the designed stack cells with a coolant flow channel were experimentally evaluated, and the thermal characteristics were also analyzed using monitored temperatures inside specific stack cells by considering the different inlet coolant temperatures of 50 °C, 60 °C and 70 °C. It was found that the stack had the greatest power performance and minimum temperature increment of the inlet coolant at a temperature of 70 °C. The water phase transition heat transfer inside the stack was found to play a significant role in the thermal balance. The temperature distribution of the stack cell had a symmetrical convex curve from the center to the margin. The temperature gradient of the stack cell along the coolant flow direction was introduced to characterize the temperature uniformity. The linear development between the temperature gradient and the current density was determined adequately using a curve fitting. In addition, a lower fitting linear slope was obtained for a higher inlet coolant temperature, and this signified that a higher inlet coolant temperature could improve the temperature uniformity and power performance of PEMFCs.

Several Important Aspects of H2-air PEMFC Engine

A single-phase, non-isothermal model for PEM fuel cells

Experimental study on the thermal management of an open-cathode air-cooled proton exchange membrane fuel cell stack with ultra-thin metal bipolar plates

Experimental study on the dynamic response of voltage and temperature of an open-cathode air-cooled proton exchange membrane fuel cell

Thermodynamic Modeling and Performance Analysis of Vehicular High-Temperature Proton Exchange Membrane Fuel Cell System

Performance of the 5 kW H2-air proton exchange membrane fuel cell

Numerical investigation of parameter distributions in high-temperature PEMFCs under various cooling surface temperature gradients

Study on the Heat and Mass Transfer Mechanisms of Liquid-Cooled PEMFC Stacks Based on Non-Isothermal Model

Experimental study of voltage uniformity and stability of H 2 /O 2 PEM fuel cell stack with dead-end anode and recirculation cathode

Study on the influence of the hydrogen–oxygen stoichiometric ratio on the power performance improvement in a large-scale PEMFC stack

Optimization of control strategy for air-cooled PEMFC based on in-situ observation of internal reaction state

Research on Low-Temperature Heat Exchange Performance of Hydrogen Preheating System for PEMFC Engine

Improved flow field design for air-cooled proton exchange membrane fuel cells

Experimental study of the thermal and power performances of a proton exchange membrane fuel cell stack affected by the coolant temperature

Experimental Investigation and Comprehensive Analysis of Performance and Membrane Electrode Assembly Parameters for Proton Exchange Membrane Fuel Cell at High Operating Temperature

Investigation of Heating and Cooling in a Stand-Alone High Temperature PEM Fuel Cell System

Investigation of non-uniform temperature distribution in air-cooled proton exchange membrane fuel cells with multizone temperature measurement

Influence of cathode air supply mode on the performance of an open cathode air-cooled proton exchange membrane fuel cell stack

Investigation on the temperature uniformity and efficiency of cold start-up for proton exchange membrane fuel cell stack based on catalytic hydrogen/oxygen method

Proton Exchange Membrane Fuel Cell(pemfc) Stack for Vehicles

Effects of operating conditions on the performance uniformity of the proton-exchange membrane fuel cell stack