Abstract:The effects of temperature on the tribological and dynamic mechanical properties (DMP) of aromatic liquid-crystal poly(ester-co-amide) were investigated. Specimens for the DMA test and friction and wear test were prepared by compression molding at elevated temperature. The dynamic mechanical properties of the resulting compression-molded liquid crystal polymer (LCP) specimens were evaluated on a Perkin-Elmer DMA instrument, in a three-point bending mode, at a heating rate of 10°C/min and frequency of 1Hz from room temperature to 250°C. The friction and wear behavior of the compression-molded LCP specimens sliding against SA52100 steel in a ball-on-disk configuration was evaluated on a high-temperature friction and wear tester from 25 to 300°C. The worn surface morphologies of the compression-molded LCP specimens were observed on a scanning electron microscope. It was found that the tribological and dynamic mechanical properties of the LCP strongly depended on the test temperature. Namely, the friction coefficients decreased significantly and the wear rate increased considerably with increasing temperature. This was attributed to the enhanced softening and plastic deformation of the LCP at elevated temperature. The LCP experienced severe plastic deformation, flowing and local melting owing to the destruction of the stiff backbones of the polymeric molecules at excessively high temperature, thus the largest wear rate of the tested LCP was generated at 300°C. Such a trend in the friction and wear behavior of the compression-molded LCP with temperature conformed well to the corresponding worn surface morphologies. Namely, the LCP worn surface was characterized by mild plastic deformation and micro-cracking as the LCP disk slid against the steel ball at 50°C, whilst at 100°C, the plastic deformation and adhesion became severe and the micro-cracking disappeared owing to the plastic flow. The plastic deformation and adhesion became increasingly more severe with further increase of the test temperature up to 150, 200, and 250°C, owing to the increased plastic flow and local softening and melting of the LCP. Moreover, the storage modulus of the compression-molded LCP greatly decreased with increasing temperature, as did the loss modulus, while the complex modulus and tan δ increased with increasing temperature, which agreed well with the corresponding trend of the tribological behavior with temperature. It was confirmed that the dynamic mechanical properties of the polymer were an important factor of the high temperature tribological behavior.

Experimental research on temperature – Dependent dynamic interface interaction between marine coral sand and polymer layer

Experimental Study of Cyclic Shear Stiffness and Damping Ratio of Carbonate Sand-Steel Interface

The Temperature-Dependent Monotonic Mechanical Characteristics of Marine Sand–Geomembrane Interfaces

Effect of Temperature on the Tribological and Dynamic Mechanical Properties of Liquid Crystalline Polymer

Monotonic Behavior of Interface Shear Between Carbonate Sands and Steel

Investigation on Concrete-Pcm Interface under Elevated Temperature: at Material Level and Member Level

Study on Shear Behavior of Concrete-polymer Cement Mortar at Elevated Temperature

Cyclic behavior of interface shear between carbonate sand and steel

Dynamic mechanical behavior of different coral sand subjected to impact loading

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Mechanical Behaviors of Interaction Between Coral Sand and Structure Surface

Experimental study of interface performance between calcareous sand and steel pile with different surface roughness and temperatures

Shear Band Between Steel and Carbonate Sand Under Monotonic and Cyclic Loading

Experimental Study on the Mechanical Strength, Deformation Behavior and Infiltration Characteristics of Coral Sand

Experimental and analytical investigations on the behavior of interface between concrete and polymer cement mortar under hygrothermal conditions

Experimental research on reinforcement-soil interface stiffness and damping ratio under cyclic shearing

Dynamic Shear Behavior of Interface for Clay Reinforced with Geogrid Encapsulated in Thin Layers of Sand

Drained shear behavior of coral sand-diatom mixtures

Effect of the particle shape on the shear mechanical behavior of coral sand

Effects of Temperature and Moisture on Concrete-PCM Interface Performance

Experimental investigation and discrete element method simulation on mechanical properties and failure mechanism of polymer-stabilized sand