Abstract:IntroductionMRI has been increasingly used in radiation therapy to facilitate tumor and organ delineation and assess treatment response. Diffusion MRI can provide cellularity information and may enable functional‐based treatment planning and adaptation. However, strong distortion associated with the conventional diffusion‐weighted single‐shot echo‐planar imaging (DW‐ssEPI) sequence is problematic for accurate target delineation. The goal of this work is to propose a 3D diffusion sequence with minimal distortion for radiation therapy applications.MethodsA 3D diffusion‐prepared magnitude‐stabilized balanced steady‐state free precession sequence (DP‐MS‐bSSFP) was developed. A 2D navigator was acquired during the linear catalyzation stage of the bSSFP readout to estimate the phase, which was then used in a plane‐by‐plane low‐rank constrained reconstruction to correct the shot‐to‐shot k‐space inconsistency. A diffusion phantom was scanned to evaluate and compare the geometric reliability and apparent diffusion coefficient (ADC) accuracy with the conventional DW‐ssEPI. Eight landmarks were selected on each slice of the images to calculate the target registration error (TRE), which was used as a surrogate for geometric fidelity. The phantom was scanned under both 0℃ and room temperature. Brain scans were performed on five healthy volunteers. In the first volunteer, protocols of 1, 2, and 4 shots per Kz plane were compared. In vivo geometric fidelity and ADC accuracy were evaluated on the remaining four volunteers using the protocol of four shots per Kz plane. In the geometric fidelity study, 8–10 landmarks were picked on each slice to calculate the TRE. Regions of interest were placed on the white matter, the cerebellum, and the cerebrospinal fluid region to evaluate the ADC agreement between DW‐ssEPI and DP‐MS using the Bland‐Altman plot. All scans were performed at 1.5 mm isotropic resolution to meet the high‐resolution requirement of many radiotherapy applications.ResultsThe DP‐MS had drastically improved geometric accuracy compared with DW‐ssEPI on the phantom. The mean TRE decreased from 2.09 mm to 0.70 mm. The percentage difference of the ADC values between the two diffusion sequences were less than 5.5% and 7% for the 0℃ and room temperature study, respectively. The DW‐ssEPI had strong distortion and susceptibility‐related artifacts at tissue air boundary, whereas distortion was minimal in DP‐MS images. Overall, the mean/max TRE was over 2 mm/7 mm in the volunteers for DW‐ssEPI, whereas less than 0.8 mm/2 mm for DP‐MS. Good ADC agreement was observed for the white matter, the cerebellum, and the CSF based on the Bland‐Altman plots.ConclusionA 3D diffusion sequence was developed and validated. It provided high‐resolution diffusion imaging with mean distortion less than 1 mm at 1.5 T, and is a promising imaging technique for treatment planning and adaptive radiotherapy.

Linearity and bias of proton density fat fraction across the full dynamic range of 0–100%: a multiplatform, multivendor phantom study using 1.5T and 3T MRI at two sites

Free-breathing liver fat quantification using a multiecho 3D stack-of-radial technique.

Accelerated K‐space Shift Calibration for Free‐breathing Stack‐of‐radial MRI Quantification of Liver Fat And

3D Isotropic Resolution Diffusion-Prepared Magnitude-Stabilized Bssfp Imaging with High Geometric Fidelity at 1.5 Tesla

Comparative analysis of hepatic fat quantification across 5 T, 3 T and 1.5 T: A study on consistency and feasibility

Comparison of Vendor-Independent Software Tools for Liver Proton Density Fat Fraction Estimation at 1.5 T

Liver Fat Content Measurement with Quantitative CT Validated Against MRI Proton Density Fat Fraction: A Prospective Study of 400 Healthy Volunteers.

Physics-informed Multi-Modal Imaging-Based Material Characterization for Proton Therapy

Improved liver fat and R 2 * quantification at 0.55 T using locally low-rank denoising

Confidence maps for reliable estimation of proton density fat fraction and R2* in the liver

R2* Impact on Hepatic Fat Quantification With a Commercial Single Voxel Technique at 1.5 and 3.0 T

Using Longitudinal MRI to Manage Proton Range Uncertainty for Pediatric Proton Craniospinal Irradiation.

Photon-counting CT using multi-material decomposition algorithm enables fat quantification in the presence of iron deposits

Multimodal Imaging-based Material Mass Density Estimation for Proton Therapy Using Physics-Constrained Deep Learning

Comparison of different MR fat quantification methods at 3.0 T in a phantom study

Fat Quantification in Dual-Layer Detector Spectral Computed Tomography

Unbiased and reproducible liver MRI-PDFF estimation using a scan protocol-informed deep learning method

Multimodal imaging-based material mass density estimation for proton therapy using supervised deep learning

Improved liver fat and R2* quantification at 0.55 T using locally low‐rank denoising

A heterogeneous phantom study for investigating the stability of PET images radiomic features with varying reconstruction settings

MRI-based Material Mass Density and Relative Stopping Power Estimation via Deep Learning for Proton Therapy