Abstract:A cardiac biomarker (CB) is an important substance released into the blood during heart damage. CB measurements help in the detection of concentric levels in cardiac troponin I. The increased troponin level in the blood can lead to the major cause of cardiac injury. Hence it is necessary to monitor the troponin level of blood. Accurate troponin I detection sensors detect the troponin level in blood. The biosensor signal is converted into an electrical signal of very low voltages. However, these electrical signals are too low. Hence, a bio-medical amplifier is introduced with analog to digital converters and compressors to amplify, capture, transfer and digitize the biosensor signal with less power and area consumption. A bio-amplifier is presented with programmable bandwidth and gain, but the task is challenging. Hence, a fully balanced bio-medical gain amplifier using a two-level CNTFET based operational amplifier (op-amp) (BGA-2C-opamp) is proposed in this work. This particular work uses two stages of CNTFET-based op-amp and presents an input capacitor for blocking the DC offset voltages. This coupling input capacitor operates the bio-medical amplifier gain using an extra load capacitor at the output. The coupling feedback resistor and capacitor are used in this amplification stage to provide a small pole frequency. The proportion of input and the feedback capacitors determines the gain of the amplification stage. To develop a two stage CNTFET-based op-amps, the trans-conductance to drain current ratio measurement is used in this case. Moreover, the bias currents of the quasi-resistors used in the feedback circuit are adjusted to achieve the cut-off programmability. The proposed BGA-2C op-amps are carried out in the cadence Virtuoso tool and analyze the proposed system's effectiveness in magnitude response, phase response, transient response, gain, total harmonic distortion, input referred noise, phase margin, common mode rejection ratio and power supply rejection ratio. In addition to this, the performance measures of delay (D), power (p) and power delay product are examined under different chirality vectors; also, the Monte Carlo analysis is examined.

Design of a Tunable Gain CMOS Current Feedback Instrumentation Amplifier for Space Applications

A novel current-mode instrumentation amplifier with Rail-to-Rail input and output

An Analysis and Implementation of Common Mode Feedback in High-Speed Fully Differential Op-Amp

Design of a novel CMOS instrumentation amplifier using 90 nm technology

Design of Differential Variable-Gain Transimpedance Amplifier in 0.18 Μm SiGe BiCMOS

An Inductorless 5-GHz Differential Dual Regulated Cross-Cascode Transimpedance Amplifier using 40 nm CMOS

A New Design Topology for Low-Voltage CMOS Current Feedback Amplifiers

Design of Cmos Instrumentation Amplifier

A 130-Db CMRR Instrumentation Amplifier with Common-Mode Replication

VDTA based transadmittance mode instrumentation amplifier with experimental results

A PVT-Robust and 73.9 mHz High-Pass Corner Instrumentation Amplifier with an SCF-SCR-PR Hybrid Feedback Resistor

Design of High Performance Operational Transconductance Amplifier

An AC-Coupled Instrumentation Amplifier Achieving 110-Db CMRR at 50 Hz with Chopped Pseudoresistors and Successive-Approximation-Based Capacitor Trimming.

Reconfigurable Low-Power CMOS Amplifier Stages for Broadband Impedance Spectroscopy

Research and Design of Wide Input Common-Mode Range Current-Sense Amplifier

Design of Common-Mode Feedback for High-Gain Charge Amplifier

A programmable gain amplifier based on a two-level CNTFET op amp with optimized trans-conductance to drain current ratio

Design of High-Side Current Sense Amplifier with Ultra-Wide ICMR

ECG AMPLIFIER DESIGN

Design of a Wideband CMOS Variable Gain Amplifier

A Design of CMOS Fully Differential Trans-independence Amplifier for Biological Signal Collection