Abstract:Hybrid electric vehicle (HEV) and plug-in hybrid electric vehicle (PHEV) require high power energy sources which are inexpensive and safe. Among various battery materials, 5V LiMn1.5Ni0.5O4 spinel materials are especially of interests for these vehicle applications because of their high operating voltage of ~4.7V and because manganese is inexpensive and less toxic than Ni and Co. However, the cycle life of these cathodes is inadequate and elevated temperature cycling cause rapid loss of capacity of the LiMn1.5Ni0.5O4 cells. This capacity degradation can be attributed to dissolution of Mn and Ni elements, solid electrolyte interphase (SEI) formation and electrolyte decomposition with high-voltage cycling [1]. Metal oxide coatings, which are usually synthesized by solution-based coating techniques, have improved capacity retention of the LiMn1.5Ni0.5O4 cells at the elevated temperatures and have been usually synthesized by solution-based coating techniques [2,3]. Recently, we have successfully coated nanometer thick amorphous lithium phosphorus oxyntirde (Lipon) electrolytes on the surfaces of LiMn1.5Ni0.5O4 and LiCoO2 particles by a RFmagnetron sputtering technique [4,5]. Uniform subnanometer thick Lipon improved the cycling behaviors of LiMn1.5Ni0.5O4 cells dramatically, but did not impede the Mn dissolution. Although a thicker Lipon layers of a few nanometers were effective in preventing the Mn dissolution, the Lipon layers greatly reduced the specific capacity because Lipon has a very low electronic conductivity of ~10 -14 S/cm. For comparison, nanometerthick protective films of electronic/ionic mixed conductor are being evaluated. Half-cell performances of cathodes fabricated with LiMn1.5Ni0.5O4 particles coated with mixed conductor will be reported for cycling at room and

Perspective on cycling stability of lithium-iron manganese phosphate for lithium-ion batteries

A novel nanoporous Fe-doped lithium manganese phosphate material with superior long-term cycling stability for lithium-ion batteries

Cycling Stability of 5V LiMn1.5Ni0.5O4 Spinel Particles Coated with a Thin Film Mixed Conductor

Research Progress in Improving the Cycling Stability of High-Voltage LiNi0.5Mn1.5O4 Cathode in Lithium-Ion Battery

Balancing the Redox Activity Against Structure Stability in High-Voltage Manganese/iron-Based Layered Oxide Cathodes Through Copper Doping for Potassium-Ion Batteries

Mn-Rich Induced Alteration on Band Gap and Cycling Stability Properties of LiMnxFe1-xPO4 Cathode Materials.

Revealing the voltage decay of LiMn0.7Fe0.3PO4 cathodes over cycling

First‐Principles Investigations of Lithium Manganese Phosphate Cathode Materials: Advances and Prospects

Electrochemically Inert Li2MnO3: The Key to Improving the Cycling Stability of Li-Rich Manganese Oxide Used in Lithium-Ion Batteries

Improvement of the Cycling Stability of Li-Rich Layered Mn-Based Oxide Cathodes Modified by Nanoscale LaPO4 Coating

Improving the Cycling Stability of Li-Rich Mn-Based Cathodes Through Surface Modification of VOPO4

Improving the Cycling Stability of Li-Rich Mn-Based Cathodes through Surface Modification of VOPO 4

Elements Gradient Doping in Mn-based Li-rich Layered Oxides for Long-Life Lithium-Ion Batteries

Modulating Surface Architecture and Electronic Conductivity of Li-rich Manganese-Based Cathode

A Novel Strategy to Suppress Capacity and Voltage Fading of Li‐ and Mn‐Rich Layered Oxide Cathode Material for Lithium‐Ion Batteries

Electrochemically Induced Interface by LiBOB to Enhance Cycling Performance of LiFe0.4Mn0.6PO4 Cathode for Lithium-Ion Batteries

Raising the cycling stability of aqueous lithium-ion batteries by eliminating oxygen in the electrolyte

Ameliorating Phosphonic-Based Nonflammable Electrolytes Towards Safe and Stable Lithium Metal Batteries

Improving electrochemical performances of Lithium-rich oxide by cooperatively doping Cr and coating Li3PO4 as cathode material for Lithium-ion batteries

Enhancing the Cycling Stability for Lithium-Metal Batteries by Localized High-Concentration Electrolytes with 2-Fluoropyridine Additive

High Performance Li[Li0.2Ni0.13Co0.13Mn0.54](BO4)0.75x(BO3)0.25xO2-3.75x Cathode with Polyanion for Li-Ion Batteries