Abstract:High-frequency dc solid-state transformer (DCSST) plays an important role in DC bus connection, voltage conversion, electrical isolation, and bidirectional power transmission in dc distribution networks. In various DSSCT topologies, the dual-active-bridge (DAB) scheme becomes a typical solution for DCSST due to its various advantages. However, the DAB scheme still has drawbacks during practical applications. In this article, a DAB with half-bridge submodules (HSDAB) is proposed. By replacing the switches in front bridge arm with half-bridge submodules (SMs), the proposed HSDAB scheme maintains the advantages of conventional DAB and obtains bidirectional dc fault-handling capability, reducing the application of large dc capacitors and dc circuit breaker; therefore, the volume and construction cost of DCSST can be effectively reduced. Besides, a high-frequency-link (HFL) voltage regulation strategy for HSDAB is also proposed in this article. The HFL voltages can be adjusted to match the HFL transformer voltage ratio during the whole operating range, reducing the current stress, HFL reactive power, and power loss of DCSST. Moreover, the proposed HSDAB scheme can also be applied as a basic circuit to establish multiple modular architecture DCSST, flexibly connecting low-voltage dc, medium-voltage dc, and high-voltage dc buses in the dc distribution network. The topology, operation principle, control structure, corresponding bidirectional dc fault handling, and HFL voltage regulation strategy of the proposed HSDAB scheme are investigated. The experimental results verify the correctness and effectiveness of the analysis and proposed scheme.

Solid-State Transformer Architecture Using AC–AC Dual-Active-Bridge Converter

A Soft-switching Universal-input Solid State Transformer

Design and experiment of a zero-voltage-switching module for bidirectional DC solid-state transformer

An LLC -DAB Bidirectional DCX Converter with Wide Load Range ZVS and Reduced Switch Count

A Five-level AC/DC Converter for MV Solid-State Transformer

Medium Voltage Single-stage Single Active Bridge Based Solid State Transformer

Onboard DC Solid State Transformer Based on Series Resonant Dual Active Bridge Converter

Bidirectional Modular Dual Active Bridge (DAB) Converter Using Multi-Limb-core Transformer with Symmetrical LC Series Resonant Tank Based on Cascaded Converters in Solid State Transformer (SST)

A Dual-Active-Bridge With Half-Bridge Submodules DC Solid-State Transformer for DC Distribution Networks

An Enhanced Dual Active Bridge Converter With Full Domain ZVS by Utilizing a Simple Segment Control for Wide Voltage Range Applications

Single-Phase Isolated AC-AC Converters Based on the Dual Active Bridge Converter

Voltage and Power Balance Control for a Cascaded H-Bridge Converter-Based Solid-State Transformer

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

Current-Feed Single-Switch Forward Resonant DC Transformer (DCX) with Secondary Diode-Clamping.

A Three-Phase Triple-Voltage Dual-Active-Bridge Converter for Medium Voltage DC Transformer to Reduce the Number of Submodules

A Dual-Transformer Based Hybrid Semi-Dual Active Bridge Converter for Wide Voltage Range Applications Utilizing Simple Segmented Control

Coupled-Inductor-Based Dual Active Bridge Converter With Soft Switching Capability and Low Component Count

Soft Switching Method of TPS Modulated DAB Converters with Wide Band Gap Devices

A Novel Solid-State Transformer With Loosely Coupled Resonant Dual-Active-Bridge Converters

Asymmetric Modulation of Bridgeless Single‐stage Full‐bridge AC–DC Converter for Active Power Factor Correction and Zero Voltage Switching