Abstract:High-frequency dc solid-state transformer (DCSST) plays an important role in DC bus connection, voltage conversion, electrical isolation, and bidirectional power transmission in dc distribution networks. In various DSSCT topologies, the dual-active-bridge (DAB) scheme becomes a typical solution for DCSST due to its various advantages. However, the DAB scheme still has drawbacks during practical applications. In this article, a DAB with half-bridge submodules (HSDAB) is proposed. By replacing the switches in front bridge arm with half-bridge submodules (SMs), the proposed HSDAB scheme maintains the advantages of conventional DAB and obtains bidirectional dc fault-handling capability, reducing the application of large dc capacitors and dc circuit breaker; therefore, the volume and construction cost of DCSST can be effectively reduced. Besides, a high-frequency-link (HFL) voltage regulation strategy for HSDAB is also proposed in this article. The HFL voltages can be adjusted to match the HFL transformer voltage ratio during the whole operating range, reducing the current stress, HFL reactive power, and power loss of DCSST. Moreover, the proposed HSDAB scheme can also be applied as a basic circuit to establish multiple modular architecture DCSST, flexibly connecting low-voltage dc, medium-voltage dc, and high-voltage dc buses in the dc distribution network. The topology, operation principle, control structure, corresponding bidirectional dc fault handling, and HFL voltage regulation strategy of the proposed HSDAB scheme are investigated. The experimental results verify the correctness and effectiveness of the analysis and proposed scheme.

A Three-Phase Triple-Voltage Dual-Active-Bridge Converter for Medium Voltage DC Transformer to Reduce the Number of Submodules

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

An LLC -DAB Bidirectional DCX Converter with Wide Load Range ZVS and Reduced Switch Count

Modeling and Analysis of 2/3-Level Dual-Active-Bridge DC-DC Converters with the Five-Level Control Scheme

Optimized Modulation and Dynamic Control of a Three-Phase Dual Active Bridge Converter with Variable Duty Cycles

A Novel Three Phase LCL Dual Active Bridge Converter to Reduce RMS Phase Current

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

Control and Study of the Three-Phase Three-Level Dual Active Bridge DC Converter

Bidirectional Modular Dual Active Bridge (DAB) Converter Using Multi-Limb-core Transformer with Symmetrical LC Series Resonant Tank Based on Cascaded Converters in Solid State Transformer (SST)

A Dual-Transformer-Based Hybrid Dual Active Bridge Converter for Plug-in Electric Vehicle Charging to Cope with Wide Load Voltages

An Efficient Dual-Active-Bridge Converter for Wide Voltage Range by Switching Operating Modes With Different Transformer Equivalent Turns Ratios

An Ideal DC Transformer for Active DC Distribution Networks Based on Constant-Transformation-Ratio DABC

An Enhanced Dual Active Bridge Converter With Full Domain ZVS by Utilizing a Simple Segment Control for Wide Voltage Range Applications

Dual-Transformer-Based DAB Converter with Controllable Integrated Inductances

An ISOP Hybrid DC Transformer Combining Multiple SRCs and DAB Converters to Interconnect MVDC and LVDC Distribution Networks

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

Interleaved Buck-Integrated Modular Multilevel DC Transformer with Wide Voltage Range for DC Distribution Grids

A Dual-Active-Bridge With Half-Bridge Submodules DC Solid-State Transformer for DC Distribution Networks

Hybrid-Bridge-Based Dual-Active-Bridge Converter With an Asymmetric Active-Neutral-Point-Clamped Three-Level Bridge

A Sharing-Branch Modular Multilevel DC Transformer with Wide Voltage Range Regulation for DC Distribution Grids

High-Efficiency Time-Division Multiplexing Modulation Technology for Modular Multiactive Bridge Converters