Abstract:A comprehensive procedure for the derivation of optimal, full-operating-range zero voltage switching (ZVS) modulation schemes for single-phase, single-stage, bidirectional and isolated dual active bridge (DAB) ac–dc converters is presented. The converter topology consists of a DAB dc–dc converter, receiving a rectified ac line voltage via a synchronous rectifier. The DAB comprises primary and secondary side full bridges, linked by a high-frequency isolation transformer and a series inductor. ZVS modulation schemes previously proposed in the literature are either based on current-based or energy-based ZVS analyses. The procedure outlined in this paper for the calculation of optimal DAB modulation schemes (i.e., combined phase-shift, duty-cycle, and switching frequency modulation) relies on a novel, more accurate, current-dependent charge-based ZVS analysis, taking into account the amount of charge that is required to charge the nonlinear parasitic output capacitances of the switches during commutation. Thereby, the concept of “commutation inductance(s)” is shown to be an essential element in achieving full-operating-range ZVS. The proposed methods are applied to a 3.7 kW, bidirectional, and unity power factor electric vehicle battery charger which interfaces a 400 $\hbox{V}$ dc-bus with the $\hbox{230} \hbox{V}_{{\rm ac}}$, 50-Hz utility grid. Experimental results obtained from a high-power-density, high-efficiency converter prototype are given to validate the theoretical analysis and practical feasibility of the proposed strategy.

Extension of Zero-Voltage Switching Region of Wide Volage Ratio Range Dual-Active-Bridge Converter by LC Antiresonant Network

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

An LLC -DAB Bidirectional DCX Converter with Wide Load Range ZVS and Reduced Switch Count

Zero Voltage Dual-LLC Resonant Soft Switching Converter for Super High Frequency Induction Heating Power Supplies

A Control Method Based on Minimum Conduction Losses for High Efficiency Isolated Dual-bridge Series Resonant Converters.

Towards Full Range Zero-Voltage Switching of DAB Converters: An Improved Multi-Mode Modulation at Light Loads Under Close-to-Unity Voltage Ratio

An Enhanced Dual Active Bridge Converter With Full Domain ZVS by Utilizing a Simple Segment Control for Wide Voltage Range Applications

Partition Variable Frequency and EPS Hybrid Control to Achieve Full Load Range ZVS for Dual Active Bridge Converters

Integrated Optimization of Dual-Active-Bridge DC–DC Converter with ZVS for Battery Charging Applications

Hybrid Control Strategy for an Integrated DAB–LLC–DCX DC–DC Converter to Achieve Full-Power-Range Zero-Voltage Switching

ZVS Control Strategy of Dual Active Bridge DC/DC Converter with Triple-Phase-shift Modulation Considering RMS Current Optimization

Coupled-Inductor-Based Dual Active Bridge Converter With Soft Switching Capability and Low Component Count

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

Totem-Pole Boost Bridgeless PFC Rectifier With Simple Zero-Current Detection and Full-Range ZVS Operating at the Boundary of DCM/CCM

A Collaborative Modulation Method of Dual-Side Backflow Power Optimization and Zero-Voltage Switching for Dual Active Bridge

Achieving Rated Power and ZVS for Dual Active Bridge Converter Considering the Interaction of Nonidealities

Zero-Voltage-Switching Single-Phase Full-Bridge Inverter With Active Power Decoupling

A Phase Shift Control of Minimal Circulating Current and ZVS Turn-On for DAB Converter

Optimal ZVS Modulation of Single-Phase Single-Stage Bidirectional DAB AC–DC Converters

Influence of Junction-Capacitance and Dead-Time on Dual-Active-Bridge Actual Soft-Switching-Range: Analytic Analysis and Solution