Abstract:A bidirectional single-phase AC to DC converter with high-frequency isolation finds a wide range of applications, including charging electric vehicles in the vehicle to grid applications. A conventional two-stage solution, where an AC-DC front-end rectifier is connected to an isolated DC-DC converter, suffers from poor efficiency due to hard switching of the AC-DC stage and poor reliability due to the existence of an electrolytic capacitance at the interstage DC link. A Dual Active Bridge (DAB) based single-stage AC-DC converter with a potential of bidirectional power flow can overcome the problems of a two stage solution. A rich literature exists in search for finding an efficient modulation strategy for this converter. This paper presents two constant switching frequency modulation strategies that support bidirectional power flow at any power factor utilizing all three degrees of freedom in modulation, also known as triple phase-shift modulation (TPS). One of the strategies minimizes RMS high-frequency transformer current over the line cycle, and the other one optimizes peak current. Hence, the conduction loss and the component stress over the entire line cycle are minimized. ZVS conditions are met for all high-frequency switching devices for the whole operating region, while the AC side converter is line frequency switched, incurring negligible switching loss. AC line current waveforms are of high quality and free from low-frequency harmonics. UPF operation is of importance for single-phase power conversion. All possible modes that the converter will experience over a line cycle for UPF operation are elaborated through detailed analysis. The proposed strategies are validated through experiment and simulation with 230 V, 50 Hz AC grid, 400 V DC, UPF, and output power of 1.2 kW.

Optimal ZVS Modulation of Single-Phase Single-Stage Bidirectional DAB AC–DC Converters

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

Closed-Form Solution for Efficient ZVS Modulation of DAB Converters

A Zero-Voltage Switching Three-Phase Inverter

Wide-Load Range Multiobjective Efficiency Optimization Produces Closed-Form Control Solutions for Dual Active Bridge Converter

Switching control strategy for full ZVS soft-switching operation of a Dual Active Bridge AC/DC converter

A Phase Shift Control of Minimal Circulating Current and ZVS Turn-On for DAB Converter

Optimal Modulation Techniques of a DAB Based Isolated Bidirectional Single-stage Single-phase AC-DC Converter

Modulation of 2/3-Level Dual-Active-Bridge DC-DC Converters for Soft-Switching and Minimum Current Stress.

Integrated Optimization of Dual-Active-Bridge DC–DC Converter with ZVS for Battery Charging Applications

Extension of Zero-Voltage Switching Region of Wide Volage Ratio Range Dual-Active-Bridge Converter by LC Antiresonant Network

Towards Full Range Zero-Voltage Switching of DAB Converters: An Improved Multi-Mode Modulation at Light Loads Under Close-to-Unity Voltage Ratio

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

Analysis and Optimal Modulation for 2/3-Level DAB Converters to Minimize Current Stress with Five-Level Control

A Hybrid Five-Variable Modulation Scheme for Dual-Active-Bridge Converter With Minimal RMS Current

A Collaborative Modulation Method of Dual-Side Backflow Power Optimization and Zero-Voltage Switching for Dual Active Bridge

Optimal Control of Multi-Level DAB Converters for Soft-Switching and Minimum Current Stress

Design and Optimization of an Efficient (96.1%) and Compact (2 kW/dm3) Bidirectional Isolated Single-Phase Dual Active Bridge AC-DC Converter

Efficiency Evaluation for DAB Converter with Reactive Power Minimization Strategy and Full ZVS Operation

ZVS Control Strategy of Dual Active Bridge DC/DC Converter with Triple-Phase-shift Modulation Considering RMS Current Optimization

Analysis and Design of Zero-Voltage-Switching Multiphase AC/DC Converters