Abstract:The interface morphology of the bonding layer has a considerable effect on the damage and failure of sandwich-structured thermal barrier coatings. This work investigated the comprehensive effects of a grooved texture produced using laser ablation on the local surface strain, interfacial stress and strain, and crack behavior of the bonding layer in a thermal barrier coating system. The distribution and evolution of the local surface strain was obtained using the digital image correlation method. The interfacial stress, and the strain between the ceramic and bonding layers, were determined through a simulation of the plane-strain model, and the morphology and propagation of cracks were observed in thermal barrier coatings under an external tensile load. The results indicated that the local surface strain of the thermal barrier coating increased with the texturization of the bonding layer, whereas the fluctuation decreased. There were two inflection points in the local surface strain–time curves, corresponding to the initiation of surface cracks and that of interfacial transverse cracks. The surface cracks were initiated earlier than those without the texturization of the bonding layer. However, the behavior of the interfacial cracks was more complicated. If the roughness of the texture, defined as Rc, was small, the surface cracks propagated vertically to the interface between the ceramic and bonding layers, and turned into transverse cracks, leading to a separation of the ceramic layer. If Rc was greater than 22 μm, the surface cracks went further down to the interface between the bonding layer and substrate, and propagated horizontally, resulting in the separation of both the ceramic and bonding layers. Meanwhile, interfacial cracking and separation were deferred. A large roughness resulted in good cohesion between the ceramic and bonding layers, and a high stiffness for the coating, which improved the damage resistance and extended the life of the coating.

Effect of the thermally grown oxide and interfacial roughness on stress distribution in environmental barrier coatings

Effect of Thermal Growth Oxide Composition and Morphology on Local Stresses in Thermal Barrier Coatings

TGO stress growth for Pt-modified aluminide bond coats during high temperature oxidation

Effect of Interface Curvature on Local Growth Behavior and Stress of Thermal Barrier Coatings

Comprehensive Understanding of the Effect of TGO Growth Modes on Thermal Barrier Coating Failure Based on a Simulation

Study of stress-driven cracking behavior and competitive crack growth in functionally graded thermal barrier coatings

Model construction and effect of thermally grown oxide dynamic growth on distribution of thermal barrier coatings

Modeling 3D TGO dynamic growth and stresses and the resulting modes of buckling failure in thermal barrier coatings

Effects of TGO growth on the stress distribution and evolution of three-dimensional cylindrical thermal barrier coatings based on finite element simulations

Phase-Field Modeling of Thermally-Grown Oxide and Damage Evolution in Environmental Barrier Coatings

Influence of non-uniform feature of thermally grown oxide thickness on the local stress state and cracking behavior in TBC

Interface stress calculation and failure behavior of TBCs on the surface of aluminum alloy with anodic oxidation

Numerical Analysis of stress evolution in thermal barrier coating system during two-stage growth of heterogeneous oxide

Finite Element Analysis of Interface Undulation and Interface Delamination in the MCrAlY Coating System Under Thermal Cycling: Considering Oxide Thickness and Top-Coat Effects

Effects of TGO growth on the interface stress distribution based on 3D pores in TBC ceramics layer

Mechanical-Chemical Coupling Effects on an Environmental Barrier Coating System under High-Temperature Water Vapour Conditions

A Diffusion-Coupled Cohesive Element Model for Cracking Analysis of Thermal Barrier Coatings

Chemo-thermo-mechanical modeling of EB-PVD TBC failure subjected to isothermal and cyclic thermal exposures

On crack evolution with texturization of bonding layer in thermal barrier coating

Construction of three-dimensional dynamic growth TGO (thermally grown oxide) model and stress simulation of 8YSZ thermal barrier coating

Analysis On Stress Distribution Of Thermal Barrier Coating System With Thermal Gradient Mechanical Fatigue