Abstract:Liquified hydrogen, which is expected to be a next-generation, environmentally friendly energy source, can be used as a cryogenic refrigerant. A cryogenic precooler (a heat exchanger between air and liquified hydrogen) has been developed for the hypersonic engine in the aerospace field. It cools the incoming air compressed at the engine's air intake using liquified hydrogen (cryogenic fuel) as a refrigerant to save the core engine from heat load and improve efficiency. However, frost formation in a precooler is a severe issue. In the present study, we developed a valid numerical method for predicting frost formation on cryogenic temperature surfaces to avoid frosting problems. The feature of the present model is considering the frost growth due to fog deposition, which has not been considered in the previous models, in addition to desublimation and fog formation. We conducted verification analyses for the frosting under forced convection on a flat cold plate at −170 °C. On an ultra-low temperature plate (−170 °C), the characteristic phenomena, including frost layer separation, were reproduced, and the frost mass and height were in quantitative agreement with the experimental data. The numerical results clarified the water vapor consumption due to fog formation and the contribution of desublimation and fog deposition to frost growth. Desublimation was dominant at the front end. On the rear side, fog formation was initially significant, and its deposition was dominant. Desublimation was suppressed because fog formation consumed water vapor. After that, the dominant mechanism gradually changed from fog deposition to desublimation because fog formation was gradually suppressed with time. These results were consistent with the experimental observation. Moreover, we also confirmed the validity of the present model for frosting on a plate of −75 °C, in which the influence of fog formation and deposition differed from at −170 °C. The model developed in this research can simulate frost formation on various temperature surfaces, from general-low temperatures where only desublimation is dominant to ultra-low temperatures where fog formation and deposition have significant impacts.

Review on Numerical Simulation of frosting behavior on Ambient air vaporizer

Numerical simulation analysis of a heat transfer tube in SuperORV

Numerical Analysis of Heat Transfer Characteristics of a Falling Film Type Plate-Fin Condenser/Reboiler

Influence of Fins Number and Frosting on Heat Transfer through Longitudinal Finned Tubes of LNG Ambient Air Vaporizers

Experimental study on heat transfer characteristics of air-heating cryogenic finned-tube vaporizer under frosting conditions

Numerical Simulation on Frost of Cryogenic Finned-Tube Vaporizer Based on Fractal Theory

Numerical Simulation of Frost Layer Growth on a Horizontal Plate

Experiment on Frost Characteristic of Air-warmed Cryogenic Finned-tube Vaporizer

Study of Frosting on a Cryogenic Surface from a Perspective of Thermal Resistance Analysis

Analysis on unsteady frosting rate for air-heated finned-tube vaporizer

Experimental study on heat transfer characteristics of flowing air on the surface of finned-tube vaporizer under frosting conditions

Heat transfer analysis of frosting under cryogenic condition

Frost model and numerical simulation of air-heating fin-tube vaporizer

Frost prediction based on a 3D CFD model of heat and mass transfer in a counter-cross-flow parallel-plate liquid-to-air membrane energy exchanger

A modeling study of spatial and temporal frost growth on the edge of windward fins for a tube-finned heat exchanger

Numerical Simulation of Frosting on Wavy Fin-and-tube Heat Exchanger Surfaces

Frost Layer Growth Behavior Study on a Cryogenic Surface with Water Vapor Content <1000 Ppmv

A numerical study on the temperature distribution of unsteady frost layer for finned-tube vaporizer

Development of a numerical model for frost formation on ultra-low temperature surfaces considering both desublimation and fog deposition

Review of restraint frost method on cold surface

Numerical study on natural convection heat transfer of fin-tube air-heating vaporizer