Development of a numerical model for frost formation on ultra-low temperature surfaces considering both desublimation and fog deposition
Akihiro Hattori,Tetsuya Sato,Takehiro Himeno,Toshinori Watanabe
DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2024.126321
IF: 5.2
2024-10-31
International Journal of Heat and Mass Transfer
Abstract:Liquified hydrogen, which is expected to be a next-generation, environmentally friendly energy source, can be used as a cryogenic refrigerant. A cryogenic precooler (a heat exchanger between air and liquified hydrogen) has been developed for the hypersonic engine in the aerospace field. It cools the incoming air compressed at the engine's air intake using liquified hydrogen (cryogenic fuel) as a refrigerant to save the core engine from heat load and improve efficiency. However, frost formation in a precooler is a severe issue. In the present study, we developed a valid numerical method for predicting frost formation on cryogenic temperature surfaces to avoid frosting problems. The feature of the present model is considering the frost growth due to fog deposition, which has not been considered in the previous models, in addition to desublimation and fog formation. We conducted verification analyses for the frosting under forced convection on a flat cold plate at −170 °C. On an ultra-low temperature plate (−170 °C), the characteristic phenomena, including frost layer separation, were reproduced, and the frost mass and height were in quantitative agreement with the experimental data. The numerical results clarified the water vapor consumption due to fog formation and the contribution of desublimation and fog deposition to frost growth. Desublimation was dominant at the front end. On the rear side, fog formation was initially significant, and its deposition was dominant. Desublimation was suppressed because fog formation consumed water vapor. After that, the dominant mechanism gradually changed from fog deposition to desublimation because fog formation was gradually suppressed with time. These results were consistent with the experimental observation. Moreover, we also confirmed the validity of the present model for frosting on a plate of −75 °C, in which the influence of fog formation and deposition differed from at −170 °C. The model developed in this research can simulate frost formation on various temperature surfaces, from general-low temperatures where only desublimation is dominant to ultra-low temperatures where fog formation and deposition have significant impacts.
engineering, mechanical,thermodynamics,mechanics