Abstract:Liquified hydrogen, which is expected to be a next-generation, environmentally friendly energy source, can be used as a cryogenic refrigerant. A cryogenic precooler (a heat exchanger between air and liquified hydrogen) has been developed for the hypersonic engine in the aerospace field. It cools the incoming air compressed at the engine's air intake using liquified hydrogen (cryogenic fuel) as a refrigerant to save the core engine from heat load and improve efficiency. However, frost formation in a precooler is a severe issue. In the present study, we developed a valid numerical method for predicting frost formation on cryogenic temperature surfaces to avoid frosting problems. The feature of the present model is considering the frost growth due to fog deposition, which has not been considered in the previous models, in addition to desublimation and fog formation. We conducted verification analyses for the frosting under forced convection on a flat cold plate at −170 °C. On an ultra-low temperature plate (−170 °C), the characteristic phenomena, including frost layer separation, were reproduced, and the frost mass and height were in quantitative agreement with the experimental data. The numerical results clarified the water vapor consumption due to fog formation and the contribution of desublimation and fog deposition to frost growth. Desublimation was dominant at the front end. On the rear side, fog formation was initially significant, and its deposition was dominant. Desublimation was suppressed because fog formation consumed water vapor. After that, the dominant mechanism gradually changed from fog deposition to desublimation because fog formation was gradually suppressed with time. These results were consistent with the experimental observation. Moreover, we also confirmed the validity of the present model for frosting on a plate of −75 °C, in which the influence of fog formation and deposition differed from at −170 °C. The model developed in this research can simulate frost formation on various temperature surfaces, from general-low temperatures where only desublimation is dominant to ultra-low temperatures where fog formation and deposition have significant impacts.

A novel numerical simulation approach for cryogenic CO 2 frosting in binary mixture gas by integrating desublimation and gas-solid phase equilibrium models

Process optimization of CO2membrane and cryogenic hybrid separation

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

Study of Frosting on a Cryogenic Surface from a Perspective of Thermal Resistance Analysis

Modeling, Characteristic Analysis, and Optimization of Ideal Internal Thermally Coupled Air Separation Columns

Numerical Simulation on Frost of Cryogenic Finned-Tube Vaporizer Based on Fractal Theory

Molecular dynamics simulation of the transport properties and condensation mechanism of carbon dioxide

Design and analysis of cryogenic CO2 separation from a CO2‐rich mixture

Experiment investigation on carbon dioxide capture by cryogenic desublimation

Nucleation and condensation characteristics of carbon dioxide in natural gas: A molecular simulation perspective

Simulation of H2S and CO2 Removal from IGCC Syngas by Cryogenic Distillation

Frost Layer Growth Behavior Study on a Cryogenic Surface with Water Vapor Content <1000 Ppmv

Complete Equation-Oriented Approach for Process Analysis and Optimization of A Cryogenic Air Separation Unit

Study on separation of CO2 condensation from natural gas based on cellular automaton method

Mechanisms of Trace Water Vapor Frosting on a Cryogenic Surface in Nitrogen Gas Flow

Experimental study of frosting characteristics of trace water vapor under cryogenic wind tunnel conditions

Cryogenic Process Optimization for Natural Gas Purification: Predictive Modeling of Methane-CO2 Solid-Vapor Phase Equilibrium Using Response Surface Methodology

Thermodynamics analysis of CO2 condensation in supersonic flows for the potential of clean offshore natural gas processing

Experimental Study of Carbon Dioxide Desublimation and Sublimation Process on Low Temperature Surface

Development of a numerical model for frost formation on ultra-low temperature surfaces considering both desublimation and fog deposition

Experimental study on heat transfer characteristics of air-heating cryogenic finned-tube vaporizer under frosting conditions