Impact of Initial Cooling Process on Frosting Characteristics of a Cryogenic Surface under Different Water Vapor Content Conditions

Hengyang Ye,Wenhan Shu,Yinghe Qi,Song Fang,Shaolong Zhu,Hanying Jiang,Xiaoqin Zhi,Limin Qiu,Kai Wang
DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2024.126355
IF: 5.2
2025-01-01
International Journal of Heat and Mass Transfer
Abstract:Widespread frosting typically leads to negative effects. Elucidating the mechanisms and characteristics of frosting is essential for developing effective frost control technologies. Practical applications usually include a cooling process, but the impact of the initial cooling process on the frosting characteristics of a cryogenic surface under different water vapor content conditions is scarcely reported. Utilizing a cryogenic visualization experimental setup, the impact of the initial cooling process on frosting characteristics with different water vapor content (60-1200 ppmv) was studied. Without an initial cooling (i.e., cryogenic surface with a fixed temperature around 120 K), the impact of water vapor content on the frosting process is relatively minor due to the same frosting mechanism. In contrast, with an initial cooling (i.e., surface temperature decreasing from 293 to 120 K), different water vapor content conditions may bring significantly different frost crystal morphology and thickness due to the transition in frosting mechanisms. Therefore, different water vapor content conditions exhibit different sensitivities to the initial cooling process. As for 60 ppmv, the average frost surface height and roughness after frosting 120 min with initial cooling are only 1.1 and 1.1 times those without initial cooling. However, when increasing to 1200 ppmv, these values after frosting 30 min significantly increase to 11.5 and 37.8 times, respectively. This study provides valuable insights into understanding frosting mechanisms and characteristics under different condition.
What problem does this paper attempt to address?