Abstract:Deep-narrow slots (DNSs) (width 2 mm) are inherent features in die-casting molds as heat-dissipating slots and turbomachinery components for seal slots. Electrochemical milling (EC-milling) is a flexible method to machine variety of structures by controlling the tool path. The process employs a tubular tool with a flat end face through which the electrolyte is supplied coaxially. However, owing to the small inter-electrode gap (IEG), the quantity and velocity of electrolyte flowing into the IEG are weakened during machining of DNSs. This reduces the machining quality and efficiency. Therefore, this paper proposes a method of EC-milling of DNSs with a pulsating flow field. A tubular tool with a wedge-shaped end face (WS-tube) is designed, and both the quantity and velocity of electrolyte flowing into the IEG will be changed with the rotation of WS-tube. Thus, a pulsating flow field is generated which can enhance the mass transport in the IEG. Consequently, both the machining efficiency and quality are improved. Flow-field simulation results indicate that as compared with the traditional flat end face tube (F-tube), WS-tube can generate a periodic pulsating flow field in both front and side IEG, and the peak electrolyte flowing velocity is also increased. The experiment results reveal that compared to that of 0.24 mm/min with F-tube, the maximum feeding speed reaches to 0.42 mm/min with WS-tube, and both the surface quality and taper are improved at the same time. Increasing the rotation speed of tube tool and pulse frequency further enhances the transport of electrolytic by-products, and the machining quality is improved. With the optimized parameters, a 5 mm deep DNS with width of 1.48 mm ± 0.02 mm, taper of 1.44° ± 0.27° and the surface roughness (Ra) of 0.7 μm has been successfully fabricated.

Electrochemical machining of multistage inner cone hole assisted by hydraulic self-driven rotating magnetic field

Study on improving the surface roughness of multi-stage internal cone hole by rotating magnetic field assisted electrochemical machining

Machining performance enhancement of deep micro drilling using electrochemical discharge machining under magnetohydrodynamic effect

Performance improvement of high-speed EDM and ECM combined process by using a helical tube electrode with matched internal and external flushing

Analysis of flow field for ECM square deep hole with two-section square cone combination cathode

Electrochemical Curved Hole Drilling by Magnetic Manipulation of a Steel Ball Electrode

Multiphysics Research on Electrochemical Machining of Micro Holes with Internal Features

Electrochemical machining of a rhombus hole with synchronization of pulse current and low-frequency oscillations

Electrochemical Machining for Micro Holes with High Aspect Ratio on Metal Alloys Using Three-Electrode PPS in Neutral Salt Solution

Analysis of electrochemical machining of involute internal spline by foamed metal cathode

Electrochemical Jet Machining in Deep-Small Holes with Gas Assistance: Generating Complex Features on Internal Surfaces

Electrochemical magnetorheological finishing for hard-to-machine functional materials with nanometer-scaled surface roughness

Deionized Water Electrochemical Machining Hybridized with Alumina Powder Polishing for Microcavity of M-333 Mold Steel

Simulation study on cathode structure optimization of aluminum alloy thin-walled internal spiral deep hole electrochemical machining

Research on jet electrochemical machining with coaxial megasonic assistance

Research on Ecm Process of Micro Holes with Internal Features

The improvement of the surface morphology via magnetic field-assisted electrochemical machining

Investigation of the Material Removal Mechanism in Electrochemical Discharge Drilling Using a High-Speed Rotating Helical Tool-Electrode

A review on magnetic field assisted electrical discharge machining

Self-adjusting EDM/ECM High Speed Drilling of Film Cooling Holes

Electrochemical milling of deep-narrow slots with a pulsating electrolyte flow field