Abstract:A novel quasi-twisted miniaturized wideband branch line coupler (BLC) is proposed. The design is based on bisecting the conventional microstrip line BLC transversely and folding bisected sections on double-layered substrates with a common ground plane in between. The input and output terminals, each with a length of λg/4, and the pair of quarter-wavelength horizontal parallel arms are converted into a Z-shaped meandered microstrip line in the designed structure. Conversely, the pair of quarter-wavelength vertical arms are halved into two lines and transformed into a periodically loaded slow-wave structure. The bisected parts of the BLC are placed on the opposite side of the doubled-layer substrate and connected through four vias passing through the common ground plane. This technique enabled a compact BLC size of 6.4 × 18 mm2, which corresponds to a surface area miniaturization by ~50% as compared to the classical BLC size of 10 × 23 mm2 at 6 GHz. Moreover, the attained relative bandwidth is 73.9% (4.6–10 GHz) for S11, S33, S21, and the phase difference between outputs (∠S21 − ∠S41). However, if a coupling parameter (S41) of up to −7.5 dB is considered, then the relative bandwidth reduces to 53.9% (4.6–10 GHz) for port 1 as the input. Similarly, for port 3 as the input, the obtained bandwidth is 75.8% (4.5–10 GHz) for S33, S11, S43, and the phase difference between outputs (∠S43 − ∠S23). Likewise, this bandwidth reduces to 56% (4.5–8 GHz) when a coupling parameter (S23) of up to −7.5 dB is considered. In contrast, the relative bandwidth for the ordinary BLC is 41% at the same resonant frequency. The circuit is constructed on a double-layered low-cost FR4 substrate with a relative permittivity of 4.3 and a loss tangent of 0.025. An isolation of −13 dB was realized in both S13 and S31 demonstrating an excellent performance. The transmission coefficients between input/output ports S21, S41, S23, and S43 are between −3.1 dB to −3.5 dB at a frequency of 6 GHz. Finally, the proposed BLC provides phase differences between output ports of 90.5° and 94.8° at a frequency of 6 GHz when the input ports 1 and 3 are excited, respectively. The presented design offers the potential of being utilized as a unit cell for building a Butler matrix (BM) for sub-6 GHz 5G beamforming networks.

Theory and design of a phase-inverted balanced coupled-line DC-blocker

An Ultra Broadband Passive Vector Modulator Phase Shifter

A Wideband 6-Bit Phase Shifter with Low RMS Error in 65nm CMOS Technology

Novel Planar Compact Coupled-Line Singleended-To-Balanced Power Divider

A Compact and Broadband Balun Based on Multilayer SIW

A Compact 1.08–5.94 GHz Balun with 1○/0.07 Db Phase-/Amplitude-Imbalances Using Reverse Series Paths

Tunable Balanced Liquid Crystal Phase Shifter Based on Spoof Surface Plasmon Polaritons with Common-Mode Suppression

Input-Reflectionless 2.4–3.8 GHz Balun With Low Phase/Amplitude Imbalance Using Stacked-Coupled Microstrip Line

Multimode CRLH SIW Transmission Lines for Wideband Multiport Directional Couplers and Miniaturized Beamforming Networks

1.34-To-16.37 GHz On-Chip Balun Based on Asymmetric Stacked Spiral Transformers

Differential Signal Propagation in Spoof Plasmonic Structure and Its Application in Microwave Filtering Balun

A New Balanced-to-Balanced Power Divider/Combiner

Analysis and Simulation of Current Balancer Circuit for Phase-Gain Correction of Unbalanced Differential Signals

High common‐mode rejection balanced bandpass filter using novel coupling scheme and source‐loaded coupling technique

A Novel Compact Broadband Quasi-Twisted Branch Line Coupler Based on a Double-Layered Microstrip Line

An Advanced Broadband Absorptive Balun for Modern Communication Systems

A 3-to-78GHz Differential Distributed Amplifier with Ultra- Balanced Active Balun and Gain Boosting Techniques in 65-nm CMOS Process

Design of A Broadband Balun Based on Composite Right/Left Handed Structure

Design and improvement of a novel wideband planar balun

A wideband balanced filtering coupled‐line coupler with improved directivity based on coupled microstrip–slotline

Design of Integrated Differential Balun Circuits