Abstract:This article presents a $V$ -band (i.e., 47-75 GHz) differential four-way distributed-active-transformer (DAT) power amplifier (PA), which uses hybrid NMOS/PMOS for double nonlinearity cancellation to improve the linearity with minimal impact on the overall PA efficiency. Implemented in the 45-nm CMOS silicon-on-insulator (SOI) process, the proposed PA consists of three stages, pre-driver, driver, and PA stages, to deliver the desired gain at the $V$ -band. The PA stage includes both NMOS and PMOS transistors, while the driver stage adopts PMOS and the pre-driver stage uses NMOS transistors. This mixed NMOS/PMOS scheme provides a high-order nonlinearity cancellation, substantially improving the PA linearity, and optimizes its performance. An ultra-compact differential four-way series–parallel DAT-based power combiner is used to provide the optimum load (R $_{\text{opt}}$ ) to the mixed NMOS/PMOS PA. This proposed PA output matching network/power combiner only occupies one transformer footprint, resulting in a reduced chip area and design complexity. The PA achieves peak power-added-efficiency (PAE) of 35.4%, saturation power (P $_{\text{sat}}$ ) of 16.3 dBm, and AM–PM distortion $<$ 2 $^{\circ}$ (at output 1-dB compression point–13.5 dBm) in 50.4-58 GHz. The AM–PM distortion drops $<$ 0.5 $^{\circ}$ at 55 GHz. The PA exhibits an average PAE (PAE $_{\text{avg}}$ ) of 15.6% and rms error vector magnitude (EVM) $<$ $-$ 25 dB when transmitting a 64-QAM modulated signal with 9.5 dBm average output power (P $_{\text{avg}}$ ) at 0.5 GSym/s. The EVM remains better than $-$ 24 dB at 3 GSym/s with P $_{\text{avg}}$ of 8.1 dBm (PAE $_{\text{avg}}$ $=$ 9.1%). In addition, this PA is measured by 5G NR CP-OFDM 64-QAM modulation with multiple CCs. When using 1-CC FR2 400-MHz modulation, it achieves PAE $_{\text{avg}}$ of 14.5%, P $_{\text{avg}}$ of 10 dBm, EVM of $-$ 23.5 dB, and adjacent channel power ratio (ACPR) of $-$ 25.8 dBc. For 4-CC FR2 200-MHz modulation, the PA exhibits PAE $_{\text{avg}}$ of 8.1%, P $_{\text{avg}}$ of 8 dBm, EVM of $-$ 24.6 dB, and adjacent power channel ration (ACPR) of $-$ 24.6 dBc.

A 3-to-78GHz Differential Distributed Amplifier with Ultra- Balanced Active Balun and Gain Boosting Techniques in 65-nm CMOS Process

A Three Stage, Fully Differential 128–157 GHz CMOS Amplifier with Wide Band Matching

A compact, fully differential D-band CMOS amplifier in 65nm CMOS

Fully Differential mm / sub-mm Wave CMOS Amplifiers

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

Compact CMOS Baluns for the 4–10 GHz Band Applications

Design and Analysis of a 26–34.5-Ghz Power Amplifier with Balanced Mismatch Reduction and Interstage Matching

Design and Analysis of an Ultrawide-Band Distributed Drain-Pumped Mixer Using 0.18µm CMOS Technology

A High Bandwidth (DC-40 GHz) Pseudo Differential Distributed Amplifier in 0.18-μm RF CMOS

A 150Ghz High Gain Amplifier Based on over Neutralization Technique and Marchand Balun Matching Networks in 65nm CMOS

A 26-38GHz Ultra-Wideband Balanced Frequency Doubler in 0.15µ m GaAs pHEMT Process

185 - 220 GHz wideband amplifier in 40 nm CMOS

Two-Stage Distributed Amplifier from 2.9 GHz to 10.6 GHz in CMOS Technology

A 28ghz CMOS Differential Bi-Directional Amplifier for 5G NR

A Highly Linear and Efficient $V$-Band CMOS Power Amplifier Using Hybrid NMOS/PMOS for Double Nonlinearity Cancellation With Four-Way Distributed-Active-Transformer

A Broadband Amplifier With Flat Bandwidth for Modulator and Measurement Driver Circuits

A High-Gain Differential Cmos Lna For 3.1-10.6 Ghz Ultra-Wideband Receivers

Design and Realization of Ultra-Wideband Differential Amplifiers for M-Sequence Radar Applications

A Ka-band Two-way Combined Power Amplifier in 65-nm CMOS Technology