Abstract:In this article, a fully integrated 1.0–11.0-GHz wideband distributed power amplifier (DPA) monolithic microwave integrated circuit (MMIC) design is presented. Particularly, a coupled technique with bandpass (CTB) characteristic between the kth output node and the ( $k+1$ )th input node of amplification units (AUs) is adopted in the DPA design. It generates an additional signal reuse path (SRP) to reuse part of the output signal to superimpose the input signal, and then they will be reamplified to the output artificial transmission line (O-ATML). Moreover, due to the bandpass characteristic, the signal reuse can be manipulated to target the upper cutting edges of the working band to alleviate sharp gain and power roll-off. By carefully controlling the SRP, the overall gain, output power, and bandwidth are enhanced and extended. The systematic design approach for the DPA is detailed with circuit implementations and optimizations. To validate the proposed concept, a DPA MMIC prototype is implemented and fabricated in a commercial 0.25- $\mu $ m gallium nitride (GaN)-on-silicon carbide (SiC) high-electron-mobility transistor (HEMT) process. It shows the compact layout within a die size of 3.36 mm2. Under 28-V VDD power supply, the measured results show a flat $14.8\pm 1.0$ -dB small-signal gain with 10.0-GHz wide operating bandwidth and good impedance matching conditions. A saturated output power ( ${P} _{\text {sat}}$ ) of 7.25 W with peak power-added efficiency (PAE) exceeding 38.7% is achieved. The proposed DPA obtains around 1.54–2.16-W/mm2 power density associated with an average PAE of 34.5% over the entire frequency range.

A High Bandwidth (DC-40 GHz) Pseudo Differential Distributed Amplifier in 0.18-μm RF CMOS

A compact, fully differential D-band CMOS amplifier in 65nm CMOS

A Three Stage, Fully Differential 128–157 GHz CMOS Amplifier with Wide Band Matching

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 3-to-78GHz Differential Distributed Amplifier with Ultra- Balanced Active Balun and Gain Boosting Techniques in 65-nm CMOS Process

A 1.7-12.6 GHz Stage-Scaling Distributed Power Amplifier with High PAE in 0.18-Μm CMOS

20GHz Broadband GaAs PHEMT Distributed Preamplifier

Two-Stage Distributed Amplifier from 2.9 GHz to 10.6 GHz in CMOS Technology

185 - 220 GHz wideband amplifier in 40 nm CMOS

A 53-to-73ghz Power Amplifier with 74.5mw/mm2 Output Power Density by 2D Differential Power Combining in 65nm CMOS

A K-band Wideband Power Amplifier in 40-Nm CMOS with 7.6-Dbm Output Power

A Broadband Amplifier With Flat Bandwidth for Modulator and Measurement Driver Circuits

A 60ghz CMOS Power Amplifier with Fully Symmetrical Distributed Active Transformer

An 8.3% Efficiency 96–134 GHz CMOS Frequency Doubler Using Distributed Amplifier and Nonlinear Transmission Line

A Wide-Band Monolithic Differential Power Amplifier

Gain and Power Enhancement with Coupled Technique for a Distributed Power Amplifier in 0.25- μm GaN HEMT Technology

Gain and Power Enhancement With Coupled Technique for a Distributed Power Amplifier in 0.25- μm GaN HEMT Technology

Gain and Power Enhancement with Coupled Technique for a Distributed Power Amplifier in 0.25-$\Mu$m GaN HEMT Technology