Abstract:The temperature dependences of the dynamic viscosity of molten lithium and beryllium fluorides, which are considered as candidate compositions for fuel and coolant of the molten salt reactor (MSR) burner of long-lived actinides from spent nuclear fuel of a VVER 1000/1200 (pressurized water reactor), were obtained by rotational viscometry using an FRS 1600 high-temperature rheometer (Anton Paar, Austria). Molten salt mixtures 0.66LiF–0.34BeF 2 and (0.73LiF–0.27BeF 2 ) + UF 4 containing 1 and 2 mol % UF 4 were studied with regard to the intermediate and fuel circuits of the MSR. The salt mixtures were prepared by direct melting of components and certified using X-ray phase and elemental analyses. The shear rate parameter was selected according to the viscosity curves obtained in the melts at a temperature of 700°C. It was found that the viscosity does not depend on the shear rate in the range of γ = 6–20 s –1 . When measuring the temperature dependence of viscosity, the γ value was 11 s –1 . The experimentally obtained values of the viscosity of the LiF–BeF 2 –UF 4 melts in the temperature range from liquidus to 800°C are described by the linear equation log η = a + b / t , but their temperature coefficients differ noticeably, which indicates a significant dependence of the viscosity of these melts on composition and temperature. The obtained viscosity values for the 0.66LiF–0.34BeF 2 melt agree with the available published data within 7–10% in the temperature range of 650–750°C. With an increase in the LiF content, the viscosity of the melt decreases: it is 20% lower in the 0.73LiF–0.27BeF 2 melt at t = 650°C. However, when 2 mol % UF 4 is added, the viscosity of the fuel salt 0.73LiF–0.27BeF 2 + UF 4 increases by 10% at the same temperature.

Preparation of homogeneous LiF-BeF2-ZrF4 molten salt with low oxygen content

Preparation of FLiNaK molten salt

Inhibition effect of ZrF 4 on UO 2 precipitation in the LiF–BeF 2 molten salt

Effect of oxide impurities on the dissolution behavior of Th4+, Be2+ and U4+ in fluoride salts

Probing the Local Structure of FLiBe Melts and Solidified Salt by in-situ High-temperature NMR

Molten Fluoride Salt and Liquid Metal Multistage Extraction Model

Numerical analysis of the viscosity of ZrF 4 –BeF 2 molten salts for nuclear transmutation using fusion neutron sources

Control and surveillance of redox potential for 233Pa dissolution in 2LiF-BeF2 molten salt

The Viscosity of Molten Salts Based on the LiF–BeF2 System

The lithium oxide solubility in molten fluoride system CeF3 - FLiNaK

First-Principles Investigation of the Effects of UF 4 and ThF 4 Fuels on the Structural, Dynamic, and Thermodynamic Properties of LiF-NaF

A study of plutonium fluoride solubility in LiF–BeF2 melt for the substantiation of a molten salt reactor for Np, Am, Cm transmutation

Local Structure and Thermophysical Properties of the Molten Salt FNaBe Through Ab Initio Molecular Dynamics and Experimental Measurements

Study on the Mechanism of Deoxidization and Purification for Li2BeF4 Molten Salt Via Graphite Nanoparticles

First-principles molecular dynamics study of the behavior of tritium in molten LiF-BeF2 eutectic

First-principles Molecular Dynamics Study of Ionic Structure and Transport Properties of LiF-NaF-AlF3 Molten Salt

Taming the chemical instability of lithium hexafluorophosphate-based electrolyte with lithium fluorosulfonimide salts

Characterization of molten 2LiF–BeF 2 salt impregnated into graphite matrix of fuel elements for thorium molten salt reactor

Determination of Trace Oxygen in FLiNaK Molten Salt

Binary Molten Salt Electrolytes Based On Liclo4 And 2-Oxazolidinone

THREE COMPOSITIONS OF HIGH-ENTROPY MELTS OF LITHIUM, SODIUM AND POTASSIUM FLUORIDES AND CHLORIDES AS PROMISING COOLANTS FOR MOLTEN SALT REACTORS