Abstract:RF-MEMS technology is indicated as a key enabling solution to realise the high-performance and highly-reconfigurable passive components that future 5G communication standards will demand for. In this work, a novel design concept of an 8-bit reconfigurable power attenuator manufactured in the RF-MEMS technology available at the CMM-FBK, in Italy, is tested and discussed. In the current Part 1 of the contribution, the RF-MEMS power attenuator design concept is discussed. The device features electrostatically controlled MEMS ohmic switches, in order to select/deselect resistive loads (both in series and shunt configuration) that attenuate the RF signal, and comprises eight cascaded stages (i.e. 8-bit), thus implementing 256 different network configurations. In Part 2 of the article, fabricated samples are measured (S-parameters) from 10 MHz to 110 GHz in a wide range of different configurations, and modelled/simulated in with a Finite Element Method software tool. Despite the attenuator complexity, the simulation approach leads to accurate prediction of the experimental behaviour. The device exhibits attenuation levels (S21) in the range from − 10 to − 60 dB, up to 110 GHz. In particular, the S21 shows flatness from 15 dB down to 3–5 dB, from 10 MHz to 50 GHz, while less linear traces up to 110 GHz. A comprehensive discussion is developed around the voltage standing wave ratio, employed as quality indicator for the attenuation levels. Finally, margins of improvement at design level are also discussed, in order to overcome the limitations of the presented RF-MEMS device.

RF-MEMS Switched Varactors for Medium Power Applications

Intermodulation Distortion in MEMS Capacitive Switches under High RF Power

Rf Mems Switch and Its Applications

RF-MEMS for future mobile applications: experimental verification of a reconfigurable 8-bit power attenuator up to 110 GHz

Design, optimization and simulation of a low-voltage shunt capacitive RF-MEMS switch

Design of Broadband High-Frequency Multi-Throw RF-MEMS Switches

Novel design and analysis of RF MEMS shunt capacitive switch for radar and satellite communications

A Low-Voltage Lateral MEMS Switch with High RF Performance

An Ultra-Broadband Contact-Capacitive RF MEMS Switch for 15-110GHZ Applications

An Advanced Real Time Lead RF-MEMS Based Switch Design for AI Applications

Design and investigation of a novel variable reactance-based capacitive RF-MEMS switch with multifrequency operation for mmWave applications

RF-MEMS for 5G applications: a reconfigurable 8-bit power attenuator working up to 110 GHz. Part 2—Experimental characterisation of the RF behaviour

RF-MEMS for 5G applications: a reconfigurable 8-bit power attenuator working up to 110 GHz. Part 1: design concept, technology and working principles

Design and Fabrication of a Capacitive Series RF MEMS Switch

Design and Fabrication of a Low Insertion Loss Capacitive RF MEMS Switch with Novel Micro-Structures for Actuation

Scalable Contact-Capacitive MEMS Switches with High Capacitance Ratio for Millimeter-Wave Applications

Design and fabrication of X-band capacitive MEMS switches

Design and simulation of a novel electro-thermally actuated lateral RF MEMS latching switch for low power applications

RF-MEMS Technology for Future Mobile and High-Frequency Applications: Reconfigurable 8-Bit Power Attenuator Tested up to 110 GHz

Rf Mems Activities at Imetu

Design and Modeling of a Continuously Variable Piezoelectric RF MEMS Switch