Abstract:Thermal analysis and microstructure characterization provide information regarding material thermal profiles and microstructure formation. Wrought aluminium alloys offer significant advantages in terms of higher ultimate tensile strength (UTS) and yield strength but relatively poor fluidity properties. The objective of this experiment presented in this paper was to understand the relationship between solidification rate, metallurgical behaviour, and fraction phase growth of wrought aluminium 6061. This information was crucial and important to the foundry industry to understand the material behaviour that will help to cast wrought aluminium 6061. Thermal analysis and microstructure of wrought aluminium 6061 on different cooling conditions are present in this paper. In this work, Aluminium 6061 heated and melted in a graphite crucible at a temperature of 800°C. Two thermocouples located at the centre and 20 mm from the graphite crucible wall. Slow cooling rate condition experiment rig was developed by placing graphite crucible into a chamber with kaowool insulation. Normal cooling rate condition was developed by allowing the molten solidify at room temperature. Fast cooling rate condition was prepared by applying a forced airflow over the graphite crucible. The slow, normal, and high cooling rates were calculated at 0.03°C/s, 0.2°C/s and 0.3°C/s respectively. Cooling curve analysis was performed to predict various areas of solidification phase and fraction solid. In Addition, the microstructure formation was observed, recorded, and compared between different cooling conditions. The results show slow cooling rate condition formation of eutectic and solidus temperatures occurred far from liquidus temperature. The eutectic and solidus temperature was increased with the increment of the cooling rate. Furthermore, the DCP temperature of slow cooling rate condition at 638.3°C was the lowest while gives wider temperature range corresponding to the fraction solid percentage increment. Meanwhile, an increase in cooling rate refined the microstructure, improved the grain circularity and at the same time reduced the aspect ratio.

Determination of latent heats for hypoeutectic AlSi7Cu(1–4) and AlSi9Cu(1–4) alloys applying thermal analysis technique

The Specificity of Determining the Latent Heat of Solidification of Cast Hypoeutectic AlSiCu Alloys Using the DSC Method

Challenges by latent heat calculation – Competition among analytical and computational methods

Variation Law Analysis of the Latent Heat of Al-Si Alloys

Relationship between the Cu content and thermal properties of Al–Cu alloys for latent heat energy storage

Solidification Curves of AlCu, AlMg and AlCuMg Alloys

Investigating Thermal and Mechanical Characteristics of Die-Casting Aluminum Alloys: A Comprehensive Investigation via Thermal Analysis

Determination of the Solidification Curves of Commercial Aluminum Alloys

Determination of the thermophysical properties of liquid and solid Ti–6Al–4V alloy

Determination of the Solidification Chracteristics of the A356.2 Aluminum Alloy

Fast differential scanning calorimetry to mimic additive manufacturing processing: specific heat capacity analysis of aluminium alloys

Specific Heat Measurement of Stable and Metastable Liquid Ti–Al Alloys

Experimental Measurement of Vacuum Evaporation of Aluminum in Ti-Al, V-Al, Ti6Al4V Alloys by Electron Beam

Experimental and theoretical study of the microstructure evolution and thermal-physical properties of hypereutectic Al–Fe alloys

Experimental determination of the phase equilibria of aluminum-rich Al−Li−Cu alloys

Specific Heat Determination and Simulation of Metastable Ternary Ni80Cu10Si10 Alloy Melt

Surface Tension Measurement of Metastable Liquid Ti–Al–Nb Alloys

Latent Heat of TB18 Titanium Alloy during to a Phase Transition by DSC and First-Principles Methods

Effect of Different Cooling Rates Condition on Thermal Profile and Microstructure of Aluminium 6061

Determination of Heat Transfer Coefficient by Inverse Analyzing for Selective Laser Melting (SLM) of AlSi10Mg

Thermodynamic description of metastable fcc/liquid phase equilibria and solidification kinetics in Al-Cu alloys