Abstract:The effects of trace transition elements (Mn, Cr, V) on the solidification microstructure and the thermal conductivity of Al-9Si based alloys have been investigated. It was found that the effect of Mn, Cr, V on the solidification behavior and solidification microstructure is mainly related to α-Al grains via affecting heterogeneous nucleation and growth restriction, while no significant effect on the solidification behavior and microstructure of eutectic Si was observed. Compared with factors including grain size of α-Al and morphology characteristics (e.g. size, spacing, and shape factor) of eutectic Si, the solid solubility in Al matrix is confirmed to be one of the most important factors affecting thermal conductivity. Due to the larger partition coefficient of V compared with Cr and Mn, the solid solubility and the lattice distortion of α-Al in Al-9Si-xV alloy were increased significantly, thus the thermal conductivity of alloy was decreased steeply from 171.7 to 152.3 W/m·K with the content of V increasing from 15 to 1010 ppm. A linearly fitted curve reflecting the relationship between the content of the transition elements and the thermal conductivity of alloys has been proposed, which can be used to optimize the alloy composition in subsequent remelting or recycling process. Furthermore, two thermal conductivity models (H-S model and Maxwell model) also have been used to evaluate the effect of Mn, Cr, V on thermal conductivity, in which the thermal conductivity of α-Al was corrected based on the measured solid solubility. In this way, the data correlation between the experimental and fitted value based on H-S model and Maxwell model is increased from 0.18 to 0.96. These obtained results could be helpful to precisely control the composition and further improve the thermal conductivity of Al-Si based alloy during the primary production and / or recycling process.

Variation Law Analysis of the Latent Heat of Al-Si Alloys

Determination of latent heats for hypoeutectic AlSi7Cu(1–4) and AlSi9Cu(1–4) alloys applying thermal analysis technique

Relationship between the Cu content and thermal properties of Al–Cu alloys for latent heat energy storage

The Specificity of Determining the Latent Heat of Solidification of Cast Hypoeutectic AlSiCu Alloys Using the DSC Method

A Quantitative Study on the Interaction Between Silicon Content and Heat Treatment on Thermal Conductivity of Al-Si Binary Alloys

THE SELECTNESS OF HIGH-TEMPERATURE PHASE CHANGE MATERIAL AI-Si ALLOY AND EXPERIMENTAL RESEARCH ON THE CONTAINER

Challenges by latent heat calculation – Competition among analytical and computational methods

Theoretical Investigation of Thermodynamic Properties of the Al-Si-Fe Ternary Alloy

The Effect of Heat Treatments on the Microstructural Evolution of Twin-Roll-Cast Al-Fe-Si Alloys

Latent Heat of TB18 Titanium Alloy during to a Phase Transition by DSC and First-Principles Methods

The Effect of Solution Treatment on the Si Particles’ Morphology Evolution and the Thermal Conductivity and Tensile Properties of Sb-Modified Al-8Si-0.6Mg Alloys

Latent Heat of TB18 Titanium Alloy during β to α Phase Transition by DSC and First-Principles Methods

Electrical resistivity and structural heredity of hypereutectic Al-Si alloy melt

Specific Heat Determination and Simulation of Metastable Ternary Ni80Cu10Si10 Alloy Melt

The evolution on the microstructure and thermal expansion behavior of Al–50Si alloy with different P contents

Assessment of Modification Level of Hypoeu- Tectic Al-Si Alloys by Pattern Recognition of Cooling Curves

Research on the energy properties and the storage stability of Al–Si–Li ternary alloy powders

Theoretical Prediction of Structural, Mechanical, and Thermophysical Properties of the Precipitates in 2xxx Series Aluminum Alloy

Determination of Heat Transfer Coefficient by Inverse Analyzing for Selective Laser Melting (SLM) of AlSi10Mg

Heat-Transfer Properties of Additively Manufactured Aluminum Lattice Structures in Combination with Phase Change Material

Elucidating thermal conductivity mechanism of Al-9Si based alloys with trace transition elements (Mn, Cr, V)