Abstract:Existing guidance from ASTM standards on extracting mechanical properties from uniaxial tension test data is not suitable for high-volume applications because it lacks automation. The Pacific Gas and Electric Company (PG&E) has performed over 450 uniaxial tension tests on samples extracted from dozens of distinct natural gas pipeline features in support of materials verification efforts; 144 of these tests recorded the entire deformation response up to fracture and were subsequently analyzed herein. Algorithms were developed to enable automatic, batch post-processing of the tensile data. Among the mechanical properties that this software extracts from the tensile data are the power-law hardening exponent and strength coefficient. A novel algorithm was developed to calculate these power-law parameters while accommodating the range of yielding and hardening behaviors present among the low carbon pipeline steels tested in this effort. The algorithm, presented in this brief technical note, first identifies the lower limit of the hardening region by calculating the tangent modulus of the stress–strain curve, which reaches its maximum value at the onset of strain hardening. The end of uniaxial hardening coincides with the ultimate tensile stress and the end of uniform deformation. From there the algorithm computes the power-law hardening parameters using conventional linear regression. Analysis of the data shows that this approach is more accurate than two other approaches: (1) regressing from 0.2% plastic strain to the limit load, and (2) iteratively regressing to identify the region that minimizes the regression error. The advantage of this approach, over existing methods, is observed for materials that exhibit a yield plateau. To further demonstrate the utility of the strain hardening information collected during this effort, the relationship between strain hardening exponent and ratio of yield strength to ultimate tensile strength from this data was compared to those reported in previous literature pertaining to remaining life assessments of steel line pipe. Overall, the strain hardening data obtained in this algorithm indicates greater hardening in pipeline steels than some previously published results. This algorithm has been made available as part of this paper's supplementary materials.

Profilometry‐Based Indentation Plastometry and Uniaxial Testing of Pipelines: Detection of In‐Plane Anisotropy and Potential for Simplification of Test Procedures

A study of the ultimate compressive strain of local buckling in strain-based design of pipelines

Accurate Estimation of Yield Strength and Ultimate Tensile Strength through Instrumented Indentation Testing and Chemical Composition Testing

Strain Based Design Of High Strength Pipelines

Profilometry‐Based Indentation Plastometry at High Temperature

The Role Of Anisotropy, Toughness Transferability, And Weld Misalignment In The Strain Based Design Of Pipelines

A Critical Appraisal of the Instrumented Indentation Technique and Profilometry‐Based Inverse Finite Element Method Indentation Plastometry for Obtaining Stress–Strain Curves

Determining the influence of an artificial defect on the mechanical properties of a flexible pipeline material during a rupture test

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Automated Calculation of Strain Hardening Parameters from Tensile Stress vs. Strain Data for Low Carbon Steel Exhibiting Yield Point Elongation

A Quantitative Approach to Tensile Strain Capacity of Pipelines

Considerations Of Linepipe And Girth Weld Tensile Properties For Strain-Based Design Of Pipelines

Application Of Compressive Strain Capacity Models To Multiple Grades Of Pipelines

A novel pipe-segment shear test apparatus: Polypropylene pipe behaviour over sand beds vs element interface tests

A novel method for determining the stress-strain constitutive relationship of high-grade pipeline weld zone material

Inhomogeneous Strain Behaviors of the High Strength Pipeline Girth Weld under Longitudinal Loading

Stress Analysis Of Lifting And Lowering-In Process

Overall Framework Of Strain-Based Design And Assessment Of Pipelines

Integrity Assessment of Post-Peak-Moment Wrinkles

Test evaluation of high strain line pipe material

Experimental Evalua tion of the Mechanical Properties of the Metal of the Characteristic Zones of Typical Pipeline Elements