Abstract:The as-laid embedment is a key design element of deep-water pipelines, as it significantly affects the longitudinal and transverse pipe-soil interaction and thermal insulation. Due to the small-amplitude oscillations driven by the sea state as well as lay vessel motions, the as-laid embedment is significantly greater than the predictions derived from static penetration analyses. This paper presents a numerical study into the cyclic embedment behavior of deep-water pipelines in soft clay using a recently developed sequential limit analysis (SLA) technique. It directly models the evolution of model geometry and material properties through a consecutive series of small displacement analyses and incorporates the effect of strain softening and strain rate on soil strength. A rigid plane-strain pipe section is pushed-in-place and then subjected to small-amplitude cyclic lateral displacements, with an accumulated lateral pipe displacement of up to 60 diameters. Careful comparisons between the numerical results with published centrifuge data are provided to demonstrate the robustness of SLA, in terms of pipe invert trajectory and soil resistance, followed by an extensive parametric study investigating the effect of strain rate, strain softening, oscillation amplitude, and loading history. More detailed aspects of the cyclic loading behavior are discussed with reference to soil failure mechanisms and bearing capacity yield envelopes. A strong correlation between accumulated lateral pipe displacement and pipe embedment is identified, regardless of the varying oscillation amplitudes, and soil buoyancy is found to play the most significant role in determining the final pipe embedment. The present study aims to assist the development of a macro-element plasticity pipe-soil model that can be incorporated into simplified three-dimensional (3D) pipeline-seabed models, as well as to promote the application of SLA to model complex large-displacement pipe-soil interaction problems.

A novel pipe-segment shear test apparatus: Polypropylene pipe behaviour over sand beds vs element interface tests

Elasto-plastic Solution for Tunnelling-Induced Nonlinear Responses of Overlying Jointed Pipelines in Sand

Numerical Modelling of Pipe-Soil Interaction for Marine Pipelines in Sandy Seabed Subjected to Wave Loadings

Assessment Model of Pipe–soil Interaction During Large-Amplitude Lateral Displacements for Deep-Water Pipelines

Modelling lateral pipe-soil interaction on soft clay using large displacement sequential limit analysis

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

Analytical Analysis of Pipeline–soil Interaction During J-lay on a Plastic Seabed with Bearing Resistance Proportional to Depth

Buckle Propagation of Sandwich Pipes under External Pressure

Visualized direct shear test of the interface between gravelly sand and concrete pipe

Pipeline Lateral Buckling Triggered by the Residual Curvature with Tri-Linear Axial Pipe-Soil Interaction

Analytical Solution of Pipeline Upheaval Buckling Considering Bi-Linear Axial Pipe-Soil Interaction Model

Axial behaviour of steel pipelines buried in sand: effects of surface roughness and hardness

Interaction between catenary riser and soft seabed: Large-scale indoor tests

Experimental investigation on pipe-soil interaction due to ground subsidence via high-resolution fiber optic sensing

Elastoplastic Pipe-Soil Interaction Analyses of Partially-Supported Jointed Water Mains

Micromechanical Analysis of Lateral Pipe–Soil Interaction Instability on Sloping Sandy Seabeds

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Model Tests on the Adhesion Factor of Full-Scale Polyethylene-Coated Pipes in Soft and Very Soft Clays

Numerical Simulation of the Interactions between Offshore Pipeline and Seabed

On-Bottom Stability Of Subsea Lightweight Pipeline (Lwp) On Sand Soil Surface

Pipe-Soil Interaction Model For Current-Induced Pipeline Instability On A Sloping Sandy Seabed