Abstract:A robot-based laser 3D hardening method is proposed as a finishing operation to increase the wear resistance of the metal end-products. The laser hardening process of the surface layer of the products by changing its structure is one of the most effective methods of selective surface hardening. Thermal hardening of metals and alloys by laser radiation is based on local heating of a surface area under the influence of radiation and subsequent cooling of this surface area at a supercritical speed due to heat removal into the inner layers of the metal. The used robot-based laser 3D system (FANUC industrial robot and SCANLAB scanning optics) allows processing the surfaces of any complexity and geometry, including the shafts of the gear mechanism of the seed drill. It was found that the development and improvement of the technological process of manufacturing steel shafts of the gearbox of the seed drill is an urgent technological problem due to the rapid retirement of the shaft, which leads to the expenditure of time and money for its replacement. The most heavily loaded sections of the shaft were pre-estimated using the SolidWorks Simulation software package. A high-power TruDisk 8002 solid-state disk laser with a maximum laser power of 8 kW and a wavelength of laser radiation of 1030 nm is used for high-quality laser surface treatment of the AISI 1066 steel shaft of the gear mechanism. The laser surface heat treatment was carried out using a constant power strategy (continuous mode), varying the laser power in the range of 1.35–2.25 kW. Based on the Fe-Mn two-component state diagram, the critical points of the temperature of complete austenization of the studied steel were previously predicted taking into account the chemical composition of the material. Additionally, the energy density values of the laser beam with a diameter of 1 mm on the working surface was estimated. The results showed that the surface hardness of the shaft was about 2.5 times higher compared to the untreated surface. The working ranges of laser heat treatment parameters of the gearbox shaft were established to increase the hardening intensity (100–150%) of the responsible areas.

Laser surface hardening process of gear

Surface Hardening of Gears by Laser Beam Processing

X-ray diffraction comparison studies between the laser hardened gear and carburized gear

Research Progress of Gear Laser Quenching

SELECTIVE SURFACE HARDENING OF GEAR MECHANISM SHAFT BY ROBOTIC LASER 3D SYSTEM

Research on laser quenching process of 20CrMnMo gears by finite element method and experiment

Laser hardening of gear teeth using a powerful fibre laser

A Study On Laser Quenching Technology Of Automobile Gear

Method for milling hardened gear surface of spiral bevel gear

Study on laser surface hardening process of 30CrMnSiNi2A ultra-high strength steel fabricated by laser deposition manufacturing

Study on mechanism of improving wear and corrosion properties of 20CrMnTi ring gear surface by laser carburizing

High-Power Diode Laser Surface Transformation Hardening of Ferrous Alloys

Sustainable technology for remanufacturing of carburized steels by laser hardening

Technique Principle of Laser Hardening Steeland Cast Iron

Study on Laser Surface Hardening Behavior of 42CrMo Press Brake Die

Study on the quenching depth and surface hardness of metal materials by laser quenching variable parameters

Combining Ultrafast Laser Texturing and Laser Hardening to Enhance Surface Durability by Improving Hardness and Wear Performance

Influences of tooth flank finishing after fine particle shot peening on tooth surface texture and fatigue life of vacuum carbonitrided gears

Laser strengthening of air-cooled diesel engine phosphorus cast iron cylinder liner and its friction & wear properties

The effect of shot peening on the contact fatigue performance of C40 steel gears after laser surface melting

Devising of New Kind of Equipment of Pulse Electrospark Hardening