Abstract:Direct Laser Writing (DLW) using ultrashort pulsed lasers and galvanometer scanning, has become an established process for surface texturing, allowing an extensive variety of feature geometries and texture designs to be produced. The minimum feature sizes that can be generated are however limited by factors such as the laser output power, beam diameter, beam wavelength and associated optics. To address the need to produce even smaller texture features, Direct Laser Interference Patterning (DLIP) has been developed, which utilises bespoke beam splitting and converging optics to produce periodic interference fringing and enabling surface textures in the micrometric size range to be produced. In this study, the texturing of cast iron cylinder liner segments using DLW and DLIP processes is explored, to assess their tribological performance in high efficiency internal combustion engines, such as for hybrid applications. To facilitate the designs of textures and to capture high resolution data on surface interactions at specific points in the combustion cycle, the segmentation of cylinder lines and piston rings is undertaken. The results of tribology tests covering combinations of high and low speeds and contact pressures, have shown that the mechanical honing of cylinder liners could potentially be replaced with the cleaner DLIP texturing as an alternative. Optimised texture designs using the DLW process achieved up to a 54 % reduction in kinematic friction between the piston ring and textured cylinder liner surfaces, compared with mechanically honed cylinder liner segments. These results have indicated that DLW texturing offers the best improvement in friction performance in the boundary and mixed lubrication regimes at higher contact pressures, at both lower and higher sliding speeds. The results also provide useful comparative data on the performance of meso and micrometric scale textures and how they can be best applied to cylinder liners.

Laser strengthening of air-cooled diesel engine phosphorus cast iron cylinder liner and its friction & wear properties

Researches of Cast Iron Piston Rings Strengthened by Laser

Wear Performance of Cast Iron Piston Rings Strengthened by Laser

Improving the Properties of Gray Cast Iron by Laser Surface Modification

The friction of surface textured cylinder liner segments modified by Direct Laser Writing and Direct Laser Interference Patterning processes

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

Microstructure and mechanical properties of composite strengthened high-chromium cast iron by laser quenching and laser shock peening

Superior wear resistance in cast aluminum alloy via femtosecond laser induced periodic surface structures and surface hardening layer

Improving the Abrasion Resistance of Nodular Cast Iron Castings by Remelting Their Surfaces by Laser Beam

Research on laser strengthening rail steel and its wear & friction properties

Microstructure, Phase Constituents and Wear Behavior of Fe/Ni-based Laser Clad Layers

Properties of Laser-Clad Stainless Steel–Ni/WC Double-Layer Coatings

Study on Laser Surface Hardening Behavior of 42CrMo Press Brake Die

Microstructure and wear behavior of arc-shaped 40CrNiMo steel after laser hardening

Laser Surface Melting Process for Camshaft Made of Ductile Iron

Microstructure and Soil Wear Resistance of a Grey Cast Iron Alloy Reinforced with Ni and Cr Laser Coatings

Laminar plasma jet surface hardening of P20 mold steel: Analysis on the wear and corrosion behaviors

Investigation on Microstructure and Performance of Boron Cast IronCylinder Liner with Laser Remelting

Investigation on Wear Resistance of Corrugating Rolls by Laser Cladding

Structural Characteristics and Sliding Friction Properties of 40CrNiMo Steel after Broadband Laser Hardening

Corrosion and Wear Resistance Characteristics of Nicr Coating by Laser Alloying with Powder Feeding on Grey Iron Liner