Abstract:In order to improve the wear and corrosion resistance and enhance the tribological and mechanical properties of gray cast iron, the laser surface cladding technique was employed to fabricate double-layer coatings with different Ni/WC ratios on the surface of gray cast iron. The effects of laser processing parameters and the type of Ni-based alloy on the microstructure and properties of the gray cast iron matrix and laser-clad layer were investigated. A 316L stainless steel transition layer was introduced between the gray cast iron substrate and the Ni/WC coating to prevent the cladding layer from cracking. The tribological and mechanical properties of the laser-clad coatings were characterized with various tests at the macro- and micro-scales; the residual stresses on the coating surfaces were measured, and electrochemical tests were also carried out. The microstructures of the clad layers were analyzed by scanning electron microscope (SEM) and X-ray diffraction (XRD). The results show that the laser-clad layers exhibit excellent vibration and noise reduction performance, which is partially due to the reduction and stabilization of the coefficients of friction (COFs) and the high levels of compressive residual stress on the surface of the laser-clad layers. The wear and corrosion resistance of the laser-clad layers are significantly improved, and the maximum wear loss of the laser-clad coating was about only 5% of that of the unclad gray cast iron substrate. This research has significance for the laser surface modification of cast iron, steel, and other metals, which is an increasingly important topic, especially in the automotive friction brake industry.

Wear Performance of Cast Iron Piston Rings Strengthened by Laser

Researches of Cast Iron Piston Rings Strengthened by Laser

Study on Friction and Wear of Cast Iron Friction Surface Layer by Laser Cladding

Investigation on the Tribological Characteristic of Laser Clad Layer

Investigation on Microstructure and Performance of Boron Cast IronCylinder Liner with Laser Remelting

Tribological Performance of Chromium Nitrided Piston Ring Coating

Reciprocating sliding friction behavior and wear state transition mechanism of cylinder liner and piston ring

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

Properties of Laser-Clad Stainless Steel–Ni/WC Double-Layer Coatings

Research on Improvement Wear Resistance of Piston Ring of Internal Combuseion Engine

Laser strengthening of air-cooled diesel engine phosphorus cast iron cylinder liner and its friction & wear properties

A review on preparation process and tribological performance of coatings for internal combustion engine piston ring

A Comprehensive Experimental Study on Tribological Performance of Piston Ring–cylinder Liner Pair

A Study On Abrasive Resistance Of Ni-Based Coatings With A Wc Hard Phase

Research on Improving Antifriction and Wear Resistance of Piston Ring for Internal Combustion Engine

Wear and Friction Behavior of Plasma Sprayed NiCrMo-NiCrBSi Alloy Anti-Friction Coatings

Low and high temperature effects on friction and wear performance of Cr-plated cylinder liner

Corrosion and Wear Resistance Characteristics of Nicr Coating by Laser Alloying with Powder Feeding on Grey Iron Liner

Dry Wear Behaviors of Wear Resistant Composite Coatings Produced by Laser Cladding

Wear Resistance Analysis of Hardening Materials for Engine Cylinder

Tribological Performances of Some Piston Ring Materials Lubricated with Low Acidity Fuel Alcohol