Abstract:An important and fast-growing technology in the realm of cryogenic detectors has recently been applied to beamline science: the superconducting Transition-Edge Sensor (TES). A TES consists of a thin metal film that is held in the superconducting-to-normal transition by a voltage bias. When a single X-ray photon is absorbed, the temperature and resistance of the film increase, which causes a negative-going current pulse with amplitude proportional to the deposited energy. The thin-film thermometer is typically coupled to a photon absorber composed of a high atomic number element such as bismuth or gold, so efficiencies near unity are possible for X-rays up to 10 keV. TESs are an example of a broader class of sensors called microcalorimeters that measure energetic events through a change in temperature. The energy resolution of a well-designed microcalorimeter is set by thermodynamic power fluctuations between the sensor and the local heat bath as well as by additional noise terms such as the Johnson noise in the sensing element. The energy resolution ΔE of a microcalorimeter is proportional to (kbT2C)1/2 where T is the sensor temperature and C is its specific heat. The temperature dependence of ΔE makes it advantageous to operate TESs at the lowest temperatures that can be conveniently reached, typically 0.1 K. For X-ray measurements between 1–10 keV, the dependence of ΔE on C limits the C of individual sensors to about 10−12 J/K, corresponding to device areas near 0.1 mm2 [1].

Titanium/silver Transition-edge Sensors for Photon-number-resolving Measurement

High intrinsic energy resolution photon number resolving detectors

Design, Fabrication, and Characterization of Ti/Au Transition-Edge Sensor with Different Dimensions of Suspended Beams

Design, fabrication and characterization of Ti/Au TES with different dimensions of suspended beams

An optical transition-edge sensor with high energy resolution

Investigation of Ti/Au Transition-Edge Sensors for Single-Photon Detection

Development of Ti/Au Transition-Edge Sensors for Single-Photon Detection

Beamline Spectroscopy of Integrated Circuits With Hard X-ray Transition Edge Sensors at the Advanced Photon Source

Transition edge sensor based detector: from X-ray to $γ$-ray

Investigation of the Superconducting Ti/PdAu Bilayer Films for Transition Edge Sensors

Investigation of Superconducting Titanium Films for Transition Edge Sensors

Measurement Of Energy Resolution For TES Microcalorimeter With Optical Pulses

Characterization, 1064 nm photon signals and background events of a tungsten TES detector for the ALPS experiment

Assessing the Aging Effect on Ti/Au Bilayers for Transition-Edge Sensor (TES) Detectors

Optical response of Al/Ti bilayer transition edge sensors

Characterization and Improvement of the Thermal Stability of TES Bolometers

Superconducting transition edge sensors with phononic thermal isolation

Properties of Low TC AlMn TES

Transition-Edge Sensor Microcalorimeters for X-ray Beamline Science

Design and Fabrication of Superconducting Transition Edge Sensor Bolometers with Background Limited Noise Performance

The superconducting transition-edge sensor single photon detector