Superconducting transition edge sensors with phononic thermal isolation

E. A. Williams,S. Withington,C. N. Thomas,D. J. Goldie,D. Osman
DOI: https://doi.org/10.1063/1.5041348
IF: 2.877
2018-10-14
Journal of Applied Physics
Abstract:The sensitivity of a low-noise superconducting transition edge sensor (TES) is determined by the thermal conductance of the support structure that connects the active elements of the device to the heat bath. Low-noise devices require conductances in the range 0.1 to 10 pW K−1 and so have to rely on diffusive phonon scattering in long, narrow, amorphous SiNx legs. We show that it is possible to manufacture and operate TESs having short, ballistic low-dimensional legs (cross section 0.5 × 0.2 μm) that contain multi-element phononic interferometers and ring resonators. These legs transport heat in effectively just 5 elastic modes at the TES’s operating temperature (<150 mK), which is close to the quantised limit of 4. The phononic filters then reduce the thermal flux further by frequency-domain filtering. For example, a micromachined 3-element ring resonator reduced the flux to 19% of a straight-legged ballistic device operating at the quantised limit and 38% of a straight-legged diffusive reference device. This work opens the way to manufacturing TESs where performance is determined entirely by filtered, few-mode, ballistic thermal transport in short, low-heat capacity legs, free from the artifacts of two level systems.
physics, applied
What problem does this paper attempt to address?