Abstract:Pleated electret HVAC filters are often used in residences and commercial buildings to mitigate the particles that originate both indoors and outdoors. However, there are two concerns on the performance of electret media: 1. Low efficiency for particles in diameter of 10-30 nm at initial filtration condition, which represent the MPPS (most penetrating particle size), and 2. Significant efficiency reduction during the loading process due to the shielding of fiber charge. In this study, a composite filter media composed of a main layer of HVAC electret media on the top and a thin layer of nanofiber at the bottom was prepared and tested for its PM2.5 removal. In the initial efficiency tests, monodisperse nanoparticles ranging 8-500 nm were used to challenge the media, It was found that the nanofiber layer can enhance the efficiency for the MPPS (10-30 nm) of electret media significantly. In the loading performance, polydisperse NaCl particles which mimicked the size distribution of typical atmospheric PM2.5 were used to challenge the media. It was found the total efficiency reduction was less than 10% for particles with sizes 50-500 nm. This reduction due to the shielding of fiber charge was much less than the electret layer (>40%) without adding nanofibers. The observation of a decent performance over the loading process was expected since the composite media made full use of both the mechanical forces and electrostatic effects. Surprisingly, the overall loading FOM (figure of merit) of the composite media was close to that of electret media, indicating that there was only a minor tradeoff of pressure drop increase when adding the nanofiber layer. In conclusion, this type of combination provided a unique structure to take advantage of electret media and a nanofiber layer for PM2.5 removal in the application of pleated HVAC filters. (C) 2017 Elsevier B.V. All rights reserved.

Mechanisms of performance degradation and efficiency improvement of electret filters during neutral particle loading

Modeling and prediction of loading characteristics of electret filter media for PM2.5

Parameters Affecting the Loading Behavior and Degradation of Electrically Active Filter Materials

Enhancement of Filtration Efficiency by Electrical Charges on Nebulized Particles

Valuations of Charging Efficiency and Critical Gap for Electron Tunnelling under Contact Electrification Model

Relationship Between Particle Charge and Electrostatic Enhancement of Filter Performance

Effect of electrostatic charge on aerosol filtration by nuclepore filters

Research note: Pressure drop and penetration for pre-charged and neutral particles on fibrous and membrane filters

Filtration Efficiency and Loading Characteristics of PM2.5 Through Composite Filter Media Consisting of Commercial HVAC Electret Media and Nanofiber Layer

Effects of Droplet Deposition on Aerosol Capture Efficiency of Bipolarly Charged Fibers

Utilizing Electrostatic Effect in Fibrous Filters for Efficient Airborne Particles Removal: Principles, Fabrication, and Material Properties

Effect of the Electrostatics on the Fibrous Filter Filtrating Fly Ash

The effect of particle size, charge, and composition on the loading characteristics of an electrically active fibrous filter material

Progress and perspective of polymer electret-based PM 2.5 filtration: Efficiencies, regeneration, and energy implications

Design of Polypropylene Electret Melt Blown Nonwovens with Superior Filtration Efficiency Stability through Thermally Stimulated Charging

Designing Multi-Layer electret filters via numerical simulation

The Effect of Electrostatic Forces on Filtration Efficiency of Granular Filters

Modeling the performance of air filters for cleanrooms using lattice Boltzmann method

Experimental Study of a Compact Electrostatically Assisted Air Coarse Filter for Efficient Particle Removal: Synergistic Particle Charging and Filter Polarizing

Electrostatic Enhancement of the Collection Efficiency of Stainless Steel Fiber Filters

The Influence of Electric Field Intensity and Particle Length on the Electrokinetic Transport of Cylindrical Particles Passing through Nanopore