Abstract:Ventilation and air distribution systems for cleanrooms in electronic industry have been overdesigned. Reducing the air supply volume of fan filter units (FFUs) is considered an energy saving measure. However, little is known about the particle removal performances after reduction in air supply volume. In this study, experiments were conducted in a chamber to investigate the effects of reducing air supply volume on the characteristic of particle distribution. The experiments were based on three FFU speed ratios (80%, 50%, and 40%) and four particle source locations (source in the subzone with and without an FFU at the heights of 1.5 m and 1.0 m) at two FFU area ratios (50% and 25%). The results were analyzed using the dimensionless particle concentrations (with respect to ideal mixing condition) in sixteen subzones within the experimental region. It was concluded that (1) the containment effect of air distribution on particle lateral dispersion was weakened with the decrease of air supply volume for FFU area ratios of both 50% and 25%; (2) most subzones have been well protected at an FFU area ratio of 50% (with dimensionless concentrations far below 0.2) regardless of the source location, and at an FFU area ratio of 25% (with dimensionless concentrations far below 0.5) for the particle source under an FFU supply airflow. However, the containment effect has been poor at an FFU area ratio of 25% for the particle source not under an FFU supply airflow regardless of the air supply volume; (3) the working face at a height of 1.0 m was slightly more affected for a source height of 1.5 m compared with a source height of 1.0 m at an FFU area ratio of 50%, while there was no significant difference in the particle removal for both source heights at an FFU area ratio of 25%; and (4) the air supply volume could be reduced by 46.7% (0.2 as the critical value) and 43.8% (0.5 as the critical value), respectively for FFU area ratios of 50% and 25% from the perspective of air distribution effectiveness. This study improves the understanding of characteristics of reduced airflow in cleanrooms.

Modeling the performance of air filters for cleanrooms using lattice Boltzmann method

Filtration performance of glass fibrous air filter media under sinusoidal flow condition

Simulation and test of flow process in air filter

Analysis and Experiments on the Characteristics of Airflow and the Air Cleanliness Protection Region under Fan Filter Units in Cleanrooms

Adjustable fiber structure design for precise aerosol filtration

Evaluation and Prediction of Fibrous Filters' Operating Performance in Residential Fresh Air System

Optimization on the performance of fibrous filter through computational fluid dynamic simulation coupled with response surface methodology

A theoretical study on the filtration efficiency and dust holding performance of pleated air filters

Numerical simulation of particle spatial distribution and filtration characteristic in the pleated filter media using OpenFOAM

Numerical Simulation of Air Flow Through A Biofilter with Heterogeneous Porous Media

Size-Dependent Removal Efficiency of Mechanical Ventilation System with Air Filtration Unit for Nanoparticles

Performance optimization of airliner cabin air filters

Experimental Study on Resistance Influencing Factors of Clean Filter Material Used in Air Purification

Indoor Airflow and Pollutant Spread Inside the Cleanroom with Micro-Porous Supplying Panel and Different Ventilation Schemes: Analytical, Numerical and Experimental Investigations

Numerical calculation and analysis of filtration performance of an effective novel structural fiber for PM2.5

Investigation of the filtration performance for fibrous media: Coupling of a semi-analytical model with CFD on Voronoi-based microstructure

The study of pleat geometry on the air filtration performance

Experimental Investigation of Particle Dispersion in Cleanrooms of Electronic Industry under Different Area Ratios and Speeds of Fan Filter Units

Three-dimensional numerical simulation and structural optimization of filtration performance of pleated cylindrical metal fiber filter

Simulation and Optimization of Flow Resistance and Noise Characteristics of Air-cleaner

Slip effect based bimodal nanofibrous membrane for high-efficiency and low-resistance air purification