Abstract:Ball indentation technique has been studied extensively in literature and it has been widely applied to determine mechanical properties of different materials because of simplicity and minimal requirement of material for the tests. Originally, the material deformation was represented in terms of a representative strain, which is a non-dimensional form of indentation diameter and a representative stress, which again is the instantaneous mean pressure multiplied by some empirical factors. It is known that the state of deformation as well as stress beneath the ball is multiaxial in nature in a ball indentation test. In this work, a new hybrid algorithm for estimation of equivalent stress and equivalent plastic strain during the process of indentation in the most stressed location beneath the ball has been developed. The algorithms uses experimental load–indentation data as well as the multiaxial stress and strain parameters obtained from 2D axisymmetric elastic-plastic finite element simulations. The stress and strain multiaxial parameters are functions of applied load, material yield stress and strain hardening exponents. The algorithm is iterative in nature and uses suitable initial guess values for material yield stress and strain hardening exponents and it converges very quickly. This method can be applied to determine the material stress–strain curve for a wide range of equivalent plastic strain, yield stress as well as plastic strain hardening exponent of the engineering materials. The data points of load vs. indentation depth as obtained directly from the ball indentation tests can be used in the new algorithm without the need for conducting unloading during the test. To illustrate the new scheme, two case studies have been presented where the results from the proposed new method have been compared with those of the existing method in literature and tensile test data to check the accuracy.

A Well-Posed Definition for Plastic Strain Rate in Indentation

Determining plastic properties of a material with residual stress by using conical indentation

Indentation Size Effect: A Study Via The Mechanism-Based Strain-Gradient Plasticity Theory

Strain Rate Sensitivity Measured from Different Continuous Macro-indentation Methods

A Critical Appraisal of the Instrumented Indentation Technique and Profilometry‐Based Inverse Finite Element Method Indentation Plastometry for Obtaining Stress–Strain Curves

The Influence of Indenter Tip Imperfection and Deformability on Analysing Instrumented Indentation Tests at Shallow Depths of Penetration on Stiff and Hard Materials

An Energy-Based Method to Extract Plastic Properties of Metal Materials from Conical Indentation Tests

Extracting the isotropic uniaxial stress-strain relationship of hyperelastic soft materials based on new nonlinear indentation strain and stress measure

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Further Investigation on the Definition of the Representative Strain in Conical Indentation

Impact of strain rate on the Indentation Size Effect: Evidence of an intimate link between Size effect, Strain Rate and Ductility in Soda-lime Silica glass

Plastic Strain Effect in Progressive Multi-Cycle Nano-Indentation Measurement

Identification of plastic properties through spherical indentation

Effects of Yield Strength and Plastic Strain Exponent on Nanoindentation Process

Indentation of Irreversibly Compressible Material: Computer Simulation

Study of plastically deformed region underneath the ball in indentation tests and evaluation of mechanical properties of materials through finite element simulation and a hybrid algorithm

Thickness-Dependent Strain Rate Sensitivity of Nanolayers Via the Nanoindentation Technique

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

The Indentation Elastic Response - Indentation Shape and the Stress Distribution

On the relationship between plastic zone radius and maximum depth during nanoindentation