Abstract:The fatigue fracture behavior of four ultrahigh strength steels with different melting processes and therefore different inclusion sizes were studied by using a rotating bar two-point bending fatigue machine in the high-cycle regime Up to 10(7) cycles of loading. The fracture surfaces were observed by field emission scanning electron microscopy (FESEM). It was found that the size of inclusion has significant effect on the fatigue behavior. For AISI 4340 steel in which the inclusion size is smaller than 5.5 mu m, all the fatigue cracks except one did not initiated from inclusion but from specimen surface and conventional S-N curve exists. For 65Si2MnWE and Aermet 100 steels in which the average inclusion sizes are 12.2 and 14.9 mu m, respectively, fatigue cracks initiated from inclusions at lower stress amplitudes and stepwise S-N curves were observed. The S-N curve displays a continuous decline and fatigue failures originated from large oxide inclusion for 60Si2CrVA steel in which the average inclusion size is 44.4 mu m. In the case of internal inclusion-induced fractures at cycles beyond about 1x10(6) for 65Si2MnWE and 60Si2CrVA steels, inclusion was always found inside the fish-eye and a granular bright facet (GBF) was observed in the vicinity around the inclusion. The GBF sizes increase with increasing the number of cycles to failure N-f in the long-life regime. The values of stress intensity factor range at crack initiation site for the GBF are almost constant with N-f, and are almost equal to that for the surface inclusion and the internal inclusion at cycles lower than about 1x10(6). Neither fish-eye nor GBF was observed for Aermet 100 steel in the present study.

Analysis of the relationship between flow characteristics of crankshaft core and fracture failures of S43CMnV steel

Failure analysis and improvement of a 42CrMo crankshaft for a heavy-duty truck

Component Structural Equivalent Research Based on Different Failure Strength Criterions and the Theory of Critical Distance

Failure Analysis of Ductile Iron Crankshaft in Four-Cylinder Diesel Engine

Cracking in a Fe–25Mn–3Si–3Al Steel

Fracture Analysis of High Chromium Cast Iron Roll on CSP Mill

Crack analysis of Cr-Mo-V-Si medium-carbon alloy steel in casting die

Fatigue fracture analysis of the 42CrMo4 crankshaft used for mining dump truck

Failure Analysis of Ductile Iron Crankshaft in Compact Pickup Truck Diesel Engine

High-cycle fatigue failure analysis of cast Al-Si alloy engine cylinder head

Roles of microstructures in high-cycle fatigue behaviors of 42CrMo high-strength steel under near-yield mean stress

Material Analysis of Crankshafts for High-speed and High-power Diesel Engine

Fracture failure analysis of 21CrMoV5.11 steel continuous casting roller

Mixed-mode Fracture Behaviors of AISI 1045 and AISI 5140 Steels in Compressor Crankshafts – Part I: Mode I-III

Fracture Analysis and Process Improvement on Industry Pump Crankshaft

Modeling on the Dynamics of Crankshaft with Crack in Fillet Region

High-Cycle Fatigue Fracture Behavior of Ultrahigh Strength Steels

Analysis of laminated crack defect in the upsetting process of heavy disk-shaped forgings

Fracture Mechanics Analysis of Fatigue Failures in Crankshafts With Drilled Holes and Surface Compression

Simulation on the Motion of Crankshaft with Crack in Crankpin-Web Fillet Region

Experimental and Numerical Study on Dynamic Fracture Behaviour of Aisi 1045 Steel for Compressor Crankshaft