Abstract:Abstract Central cracking in cross-wedge-rolled workpieces results in high wastage and economic loss. Recent cross-wedge rolling tests on two batches of steel showed that one batch formed central cracks, while the other was crack-free. The batches were both nominally of the same chemical composition and thermomechanical treatment history. In addition, both batches had passed all the standard quality assessments set for conventional forging processes. It was suspected that the different cracking behaviours were due to differences in microstructure between the two as-received steel billets, and the material in cross-wedge rolling (CWR) was more sensitive to the initial microstructure compared with other forging processes due to its specific loading condition including ostensibly compression and large plastic strain. Nevertheless, no previous study of this important problem could be identified. The aim of this study is, therefore, to identify the key microstructural features determining the central crack formation behaviour in CWR. The hot workability of the as-received billets was studied under uniaxial tensile conditions using a Gleeble 3800 test machine. Scanning electron microscope with energy-dispersive X-ray spectroscopy and electron backscatter diffraction was applied to characterise, quantitatively analyse, and compare the chemical composition, phase, grain, and inclusions in these two billets, both at room temperature and also at the CWR temperature (1080 °C). Non-metallic inclusions (oxides, sulphides, and silicates) in the billets were determined to be the main cause of the reported central cracking problem. The ductility of the steels at both room and elevated temperatures deteriorated markedly in the presence of the large volumes of inclusions. Grain boundary embrittlement occurred at the CWR temperature due to the aggregation of inclusions along the grain boundaries. It is suggested that a standard on specifying the inclusion quantity and size in CWR billets be established to produce crack-free products.

Fracture Analysis of High Chromium Cast Iron Roll on CSP Mill

Fracture failure analysis on Alloy783 bolts in medium-pressure valve bonnets of USC units

Fracture failure analysis and research on super-large-diameter roll

Fracture Analysis on Pins of Hoist Chains of a Bucket Elevator

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Fracture Analysis on A Cylindrical Shell Section of the Low-Pressure Absorption Tower

Failure analysis of a high strength Cr-containing tube used in an oil well

Analysis of the relationship between flow characteristics of crankshaft core and fracture failures of S43CMnV steel

Failure analysis for outer ring cracking of GCr15 rolling bearing

Failure Analysis on Vertical Cracking of Medium Carbon Bainitic Steel Backup Roll

Influence of Work Hardening on the Surface of Backup Rolls for a 4-High Rolling Mill Fractured during Rolling Campaign

Cause Analysis and Improvement Measures for Pipeline Cracking of 9Cr-1Mo Material

Study on Crack Forming of Centrifugal Cast High Speed Steel Roll

Investigation and prediction of central cracking in cross wedge rolling

Fracture failure analysis of the main shaft of a large sewage treatment equipment

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts

Fracture Analysis of GCr15 Steel Cycloid Gear

Fracture Analysis on Gear Shaft in Vulcanizer Tire Foundation

Failure analysis and improvement of a 42CrMo crankshaft for a heavy-duty truck

Fracture failure analysis of vertical arm of rear axle

Fracture analysis of stainless steel universal joints in power grid equipment: A comparative study of cast and forged structures