Abstract:Large-displacement shear appears between pile shaft and its surrounding soil during the penetration process, and cyclic shear is the typical feature in subsequent service load condition. In this paper, a series of interface shear tests have been conducted to investigate the sand-steel interface behaviors under large-displacement and cyclic shear. Three types of particles (quartz sand, carbonate sand and steel bead) and two normal boundary conditions (constant normal load, CNL; constant normal stiffness, CNS) were used in these tests. To simulate the large displacement shear process for monotonic installed pile, the large-displacement shear is performed using monotonic shear method. It is found that under the large-displacement shear with CNL condition, the quartz sand and carbonate sand show different breakage degrees and modes. Obvious particle breakage changes both the particle gradation and sample densification, which are the main reasons for the increase of interface friction angle. While for the cyclic shear with CNS condition, the interface strength shows a quick degradation feature, which is mainly affected by the initial shape of particles. It is also found that the previous interface shear plays a key role in this kind of degradation. When the shear displacement is small, the degradation is promoted with only a small amount of sand breakage. But if the sand breakage is significant under the large-displacement shear, abundant broken fine particles fill into the void and make the sand sample much denser. So, the degradation trend of interface strength will be suppressed. It is suggested that the previous large-displacement shear process for displacement pile should be adequately considered in the design.

Friction anlysis of large diameter steel cylinder penetration process using 3D-DEM

Three-Dimensional DEM Simulation of Plugging Behaviour of Small-Diameter Open-Ended Model Piles Penetrating Into Sand

DEM Study of the Stress Fields Around the Closed-Ended Displacement Pile Driven in Sand

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Simulation of Front End Loader Bucket–soil Interaction Using Discrete Element Method

3-D Numerical Simulation for Large-Diameter Cast-<i>In Situ</i> Tubular Pile

3-D Numerical Simulation for Large-Diameter Cast-In-Situ Tubular Pile

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Bearing capacity and deflection behaviors of large diameter monopile foundations in sand seabed

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Investigation of Modeling Non-Spherical Particles by Using Spherical Discrete Element Model with Rolling Friction

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Finite Element Analysis of Compacting Displacements of Single Jacked Pile

DEM-continuum mechanics coupling simulation of cutting reinforced concrete pile by shield machine

An FDM–DEM coupling method for analyzing the mechanical behavior of a slope reinforced by piles

Large-Deformation Analyses

Numerical simulation of cone penetration test by using CFD–DEM coupled analysis

Discrete Element Modelling of a Soil-Rock Mixture Used in an Embankment Dam