Abstract:Cement deep mixing pile (CDM) are often used to improve the stability of embankments/riverbanks in soft soil areas due to the extremely low bearing capacity of natural soft soil foundations. Especially for riverbank filling for emergency flood control. In order to accurately identify the destabilization and damage characteristics of the riverbank reinforced by CDMs, centrifugal model test was conducted to investigate the settlement characteristic of the riverbank, the force and deformation properties of the piles at different locations, as well as the destabilization and damage mechanisms of the foundation under the high gravity field. The riverbank has two slopes, a primary slope and a secondary slope in that order from the top of the riverbank downward. The results indicate that the soil below the top of the primary slope was subjected to compression, and no large horizontal displacement occurred in this region. In addition, ground collapse has occurred near the toe of the riverbank slope. Besides the most dangerous sliding surface, there are still potential sliding bodies and sliding surfaces in the foundation. The soil slip surface and the points of failure in the columns were not completely coincident. After the column failure happened, it can be used as a fast drainage channel to accelerate soil consolidation. The piles under the top of the primary slope were mainly damaged in compression without large horizontal deformation; the piles under the shoulder of the primary slope to the shoulder of the secondary slope were damaged in bending failure and carried most of the horizontal loads; and the piles under the secondary slope to the riverbed were damaged in shear failure. According to the specific damage situation of the columns, rigid piles/strength core composite piles with higher bending strength can be considered to replace some of the CDMs to effectively improve current design methods for CDM-reinforced foundation.

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Centrifuge Study on Behavior of Rigid Pile Composite Foundation under Embankment in Soft Soil

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Centrifuge modelling on tetrapod jacket foundation subjected to lateral loads

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Test Research on the Behavior of Composite Foundations Incorporating Rigid and Flexible Piles

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Experimental Study on Behavior of Composite Foundation with Rigid-Flexible Piles

Analysis of stress and failure mechanism on composite foundation improved by rigid piles under flexible foundation considering damage of piles

Stability of composite foundation improved by rigid piles under embankment considering different failure modes of piles

Centrifugal Modeling of Flexible Non-uniform Piles in Composite Foundation

Centrifuge Modelling on the Stability of Emergency Flood Control Riverbank Reinforced by Mixing Piles: Case Study of Baishan Junction, China

CENTRIFUGE MODEL TESTS AND NUMERICAL SIMULATION OF LOAD SHARING LAW FOR COMPOSITE EMBANKMENT WITH LONG AND SHORT PILES

Centrifuge modelling on the stability of emergency flood control riverbank reinforced by deep mixed column: Case Study of Baishan Junction, China

Analytical modeling for the behavior of concrete-cored cement mixing (CCM) pile composite foundation under embankment

Design of Model Concrete Piles to Reinforced Slopes for Dynamic Centrifuge Tests

Behavior of Soil Slopes Reinforced with Composite-Structural Piles

Centrifuge modelling of working performance of foundation pile embedded in expansive clay with high liquid limit

Study on Bearing Capacity of Composite Foundation with Marine Sand Compaction Pile by Centrifugal Test